Search results
Results from the WOW.Com Content Network
diagram of a double-effect falling film evaporator. Condensing vapors from flash tank B1 heat evaporator A2. •1=feed •2=product •3=steam •4=vapors. In chemical engineering, a multiple-effect evaporator is an apparatus for efficiently using the heat from steam to evaporate water. [1]
Multiple-effect distillation or multi-effect distillation (MED) is a distillation process often used for sea water desalination. It consists of multiple stages or "effects". In each stage the feed water is heated by steam in tubes, usually by spraying saline water onto them.
The best way to reduce energy consumption is by using multiple-effect evaporators. For multiple-effect evaporators, the steam from outside is condensed by the heating element of the first effect and the vapors produced from the first effect are then recycled back to the second effect, where the feed will be partially concentrated product of the ...
The reason for letting the evaporation happen in multiple stages rather than a single stage at the lowest pressure and temperature, is that in a single stage, the feed water would only warm to an intermediate temperature between the inlet temperature and the heater, while much of the steam would not condense and the stage would not maintain the ...
Concentration values of forced circulation evaporators can handle more than the limits of conventional tubular evaporators when handling feed with dissolved salts and is often used as a finishing evaporator for concentration of liquids to high solid content following low solids multi-stage, TVR or MVR evaporation. [9] Multiple heating effects ...
Multiple effect evaporation (MEE) Thermal vapor recompression (TVR) (also known as thermocompression) A combination of the three methods may be used depending on the process. For instance, a 3-effect evaporator circuit may be installed using MVR to transfer heat.
Know better, bake better!
Adding another effect reduces it to 33% and so on. A heat-saving-percent equation can estimate how much one will save by adding a certain number of effects. The number of effects in a multiple-effect evaporator is usually restricted to seven because, after that, the equipment cost approaches the cost savings of the energy-requirement drop.