enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. R-value (insulation) - Wikipedia

   en.wikipedia.org/wiki/R-value_(insulation)

   R. -value (insulation) The R-value (in K ⋅ m 2/ W) is a measure of how well a two-dimensional barrier, such as a layer of insulation, a window or a complete wall or ceiling, resists the conductive [2] flow of heat, in the context of construction. [3] R-value is the temperature difference per unit of heat flux needed to sustain one unit of ...

3. List of insulation materials - Wikipedia

   en.wikipedia.org/wiki/List_of_insulation_materials

   This is a list of insulation materials used around the world. Typical R-values are given for various materials and structures as approximations based on the average of available figures and are sorted by lowest value. R-value at 1 m gives R-values normalised to a 1 metre (3 ft 3 in) thickness and sorts by median value of the range.

4. Building insulation - Wikipedia

   en.wikipedia.org/wiki/Building_insulation

   For example, in the US the insulation standard for attics, is recommended to be at least R-38 US units, (equivalent to R-6.7 or a U value of 0.15 in SI units). [5] The equivalent standard in the UK are technically comparable, the approved document L would normally require an average U value over the roof area of 0.11 to 0.18 depending on the ...

5. Building insulation material - Wikipedia

   en.wikipedia.org/wiki/Building_insulation_material

   Closed-cell foams are superior insulators. While open-cell foams typically have R-values of 3 to 4 per inch (RSI-0.53 to RSI-0.70 per inch), closed-cell foams can attain R-values of 5 to 8 per inch (RSI-0.88 to RSI-1.41 per inch). This is important if space is limited, because it allows a thinner layer of insulation to be used.

6. Cellulose insulation - Wikipedia

   en.wikipedia.org/wiki/Cellulose_insulation

   The R-value of 3.6 to 3.8 per inch [citation needed] is good but not the best. [citation needed] Material cost per R-value is good but labor cost goes up because it takes more material and time to install than fiberglass insulation at the same R-Value [citation needed].

7. Radiant barrier - Wikipedia

   en.wikipedia.org/wiki/Radiant_barrier

   Research has shown that the insulation value of reflective bubble foil insulations and radiant barriers can vary from RSI 0 (R-0) to RSI 0.62 (R-3.5) per thickness of material. A study conducted by CMHC (Canada Mortgage & Housing Corporation) on four homes in Paris, ON found that the performance of the bubble foil was similar to an uninsulated ...