Search results
Results from the WOW.Com Content Network
Works with 15 mm miniatures where a 6 foot man would equal 15.24 mm 1:110: 2.771 mm Used for some model ships, aircraft and diecast cars. 1:108: 2.822 mm An historic size for ships, also used for rockets and spacecraft. 15 mm figure scale for wargaming is considered interchangeable with this scale. [9] 1:100: 3.048 mm
A 1:35 scale Learjet 45. 1:35 scale is the most popular scale for model military vehicles, with an extensive lineup of models and aftermarket parts available from a wide variety of manufacturers.
35 mm equivalent focal lengths are calculated by multiplying the actual focal length of the lens by the crop factor of the sensor. Typical crop factors are 1.26× – 1.29× for Canon (1.35× for Sigma "H") APS-H format, 1.5× for Nikon APS-C ("DX") format (also used by Sony, Pentax, Fuji, Samsung and others), 1.6× for Canon APS-C format, 2× for Micro Four Thirds format, 2.7× for 1-inch ...
Academy ratio 1.375:1. The Academy ratio of 1.375:1 (abbreviated as 1.37:1) is an aspect ratio of a frame of 35 mm film when used with 4-perf pulldown. [1] [2] It was standardized by the Academy of Motion Picture Arts and Sciences as the standard film aspect ratio in 1932, although similar-sized ratios were used as early as 1928.
1:72 scale is a scale used for scale models, most commonly model aircraft, where one inch on the model equals six feet (which is seventy-two inches) in real life. The scale is popular for aircraft because sizes ranging from small fighters to large bombers are all reasonably manageable and displayable.
Mass equivalent of the energy of a photon at the peak of the spectrum of the cosmic microwave background radiation (0.235 meV/c 2) [3] 10 −36: 1.8 × 10 −36 kg 1 eV/c 2, the mass equivalent of one electronvolt [4] 3.6 × 10 −36 kg Electron neutrino, upper limit on mass (2 eV/c 2) [5] 10 −33 quectogram (qg) 10 −31: 9.11 × 10 −31 kg
In the US, size names are often denoted with a code of the format nR, where the number n represents the length of the shorter edge in inches. In the normal series, the long edge is the length of the short edge plus 2 inches (10 in or less) or 3 inches (11 in and above).
Spools are 1.35 inches (3.4 cm) inches in diameter with holes of 0.30 inches (0.76 cm) inch depth. Most of the larger sets also include a driveshaft (an unfinished wooden rod without slotted ends, of an intermediate length between "green" and "violet", normally turned with a small plastic crank.