Search results
Results from the WOW.Com Content Network
A linear encoder is a sensor, transducer or readhead paired with a scale that encodes position. The sensor reads the scale in order to convert the encoded position into an analog or digital signal , which can then be decoded into position by a digital readout (DRO) or motion controller.
The string potentiometer may be connected as a three-wire tapped resistor (voltage divider), in a control circuit, or may be packaged with electronics to produce a measurement signal in a useful form, such as a variable voltage 0-10 VDC, variable current 4-20mA, pulse encoder, Bus (DeviceNet and Canbus) and RS-232 communications.
The codewords in a linear block code are blocks of symbols that are encoded using more symbols than the original value to be sent. [2] A linear code of length n transmits blocks containing n symbols. For example, the [7,4,3] Hamming code is a linear binary code which represents 4-bit messages using 7-bit codewords. Two distinct codewords differ ...
Rotary incremental encoder with shaft attached to its thru-bore opening Introduction to incremental encoders, from VideoWiki script Incremental Encoder. An incremental encoder is a linear or rotary electromechanical device that has two output signals, A and B, which issue pulses when the device is moved. [1]
This is the standard positive logic signal format used in digital circuits. forces a high level forces a low level NRZ–M: Non-return-to-zero mark forces a transition does nothing (keeps sending the previous level) NRZ–S: Non-return-to-zero space does nothing (keeps sending the previous level) forces a transition RZ: Return to zero
In the case of absolute encoders, the indicated position may be far away from the actual position and, in the case of incremental encoders, this can corrupt position tracking. In contrast, the Gray code used by position encoders ensures that the codes for any two consecutive positions will differ by only one bit and, consequently, only one bit ...
In the PalmDoc format, a length–distance pair is always encoded by a two-byte sequence. Of the 16 bits that make up these two bytes, 11 bits go to encoding the distance, 3 go to encoding the length, and the remaining two are used to make sure the decoder can identify the first byte as the beginning of such a two-byte sequence.
Linear pulse-code modulation (LPCM) is a specific type of PCM in which the quantization levels are linearly uniform. [5] This is in contrast to PCM encodings in which quantization levels vary as a function of amplitude (as with the A-law algorithm or the μ-law algorithm ).