Search results
Results from the WOW.Com Content Network
The formulas involved can be complex and in some cases, such as in the ECEF to geodetic conversion above, the conversion has no closed-form solution and approximate methods must be used. References such as the DMA Technical Manual 8358.1 [15] and the USGS paper Map Projections: A Working Manual [16] contain formulas for conversion of map ...
The Universal Transverse Mercator (UTM) is a map projection system for assigning coordinates to locations on the surface of the Earth.Like the traditional method of latitude and longitude, it is a horizontal position representation, which means it ignores altitude and treats the earth surface as a perfect ellipsoid.
To convert Transverse Mercator coordinates to lat-lon, first calculate ′, the footprint latitude— i.e. the latitude of the point on the central meridian that has the same N as the point to be converted; i.e. the latitude that has a meridian distance on the spheroid equal to N/. Bowring's formulas below seem quickest, but traditional ...
The projection is normally restricted to narrow zones (in longitude) so that both of the expansion parameters are typically less than about 0.1, guaranteeing rapid convergence. For example in each UTM zone these expansion parameters are less than 0.053 and for the British national grid they are less than 0.09.
The set of parameters can vary based on the type of project and the conventions chosen for the projection. For the transverse Mercator projection used in UTM, the parameters associated are the latitude and longitude of the natural origin, the false northing and false easting, and an overall scale factor. [7]
(On the sphere it depends on both latitude and longitude.) The scale is true on the central meridian. • The projection is reasonably accurate near the equator. Scale at an angular distance of 5° (in latitude) away from the equator is less than 0.4% greater than scale at the equator, and is about 1.54% greater at an angular distance of 10°. •
The intersection of a UTM zone and a latitude band is (normally) a 6° × 8° polygon called a grid zone, whose designation in MGRS is formed by the zone number (one or two digits – the number for zones 1 to 9 is just a single digit, according to the example in DMA TM 8358.1, Section 3-2, [1] Figure 7), followed by the latitude band letter ...
Like the UTM coordinate system, the UPS coordinate system uses a metric-based cartesian grid laid out on a conformally projected surface. UPS covers the Earth's polar regions, specifically the areas north of 84°N and south of 80°S, which are not covered by the UTM grids, plus an additional 30 minutes of latitude extending into UTM grid to ...