enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Dana 70 - Wikipedia

    en.wikipedia.org/wiki/Dana_70

    There are three pinion offsets for the Dana 70 rear axle. 1 ⁄ 2, 5 ⁄ 8 and 31 ⁄ 32 inch (13, 16 and 25 mm) offset. The first Dana 70 axles had a 1 ⁄ 2-inch (13 mm) pinion offset and were found in Dana 70HD's as well. The drawback with the 1 / 2-inch offset was that a 4.10:1

  3. GM 10.5-inch 14-bolt differential - Wikipedia

    en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

    There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs. The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles.

  4. Saginaw 9.5-inch axle - Wikipedia

    en.wikipedia.org/wiki/Saginaw_9.5-inch_axle

    The GM 9.25 IFS has been the main front differential in Four-wheel drive 3/4 Ton and 1 Ton GM trucks since 1988. The Dana 60 solid axle front end was used selectively in trucks with a higher GVWR from 1988 to 1991. The original Saginaw 9.5 differential, ring and pinion were modified to work with the independent front suspension.

  5. Dana 60 - Wikipedia

    en.wikipedia.org/wiki/Dana_60

    Pinion shaft diameter: 1.625" Pinion shaft splines: 10 or 29; Gear ratios: 3.54:1 - 7.17:1 1st Generation Dodge Cummins trucks with non-OD transmissions are equipped with 3.07:1 "Dana 61" front axles with unique differential housings and carriers with extra clearance for the very large pinion gear. They can be easily "converted" to 3.54:1 ...

  6. List of GM bellhousing patterns - Wikipedia

    en.wikipedia.org/.../List_of_GM_bellhousing_patterns

    The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...

  7. GM 4L60-E transmission - Wikipedia

    en.wikipedia.org/wiki/GM_4L60-E_transmission

    Five-pinion front and rear planetaries, along with an additional 3/4 clutch allowing 7 clutches in the input housing and induction hardened input shaft assembly, were improved to withstand up to 380 ft⋅lb (520 N⋅m) of torque. Applications: Cadillac Escalade; Cadillac Escalade EXT; Chevrolet Corvette, 2005 only; Chevrolet Silverado SS; GMC ...

  8. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. General Motors W platform - Wikipedia

    en.wikipedia.org/wiki/General_Motors_W_platform

    The transverse use of GM's LS small-block engine in the W-bodies was a major addition for 2005. The GM W Platform was phased out with the production of the new long-wheelbase Epsilon II platform . The last car produced on the W platform was the ninth generation of the Chevrolet Impala , which was replaced by the Epsilon-based tenth-generation ...