Search results
Results from the WOW.Com Content Network
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs. The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles.
The first Dana 70 axles had a 1 ⁄ 2-inch (13 mm) pinion offset and were found in Dana 70HD's as well. The drawback with the 1 / 2-inch offset was that a 4.10:1 gear ratio was the highest gear set possible. In the 1970s the 1 / 2-inch offset was phased out for a 5 ⁄ 8-inch (16 mm) offset that allowed
The GM 9.25 IFS has been the main front differential in Four-wheel drive 3/4 Ton and 1 Ton GM trucks since 1988. The Dana 60 solid axle front end was used selectively in trucks with a higher GVWR from 1988 to 1991. The original Saginaw 9.5 differential, ring and pinion were modified to work with the independent front suspension.
Pinion shaft diameter: 1.625" Pinion shaft splines: 10 or 29; Gear ratios: 3.54:1 - 7.17:1 1st Generation Dodge Cummins trucks with non-OD transmissions are equipped with 3.07:1 "Dana 61" front axles with unique differential housings and carriers with extra clearance for the very large pinion gear. They can be easily "converted" to 3.54:1 ...
The 2-1-2 forecheck, or pinch on a wide rim is an ice hockey forechecking strategy which uses two forwards deep in the offensive zone, with the remaining forward positioned high in the offensive zone, and the two defencemen positioned at the highest part of the zone near the blue line. [1]
AOL latest headlines, entertainment, sports, articles for business, health and world news.
Its design is similar to the Torsen T-2 (slightly less torque bias), and is an aftermarket part for many popular US-made solid axles for rear-wheel drive and 4x4 pick-up trucks. The Truetrac is most often used in the front axle of 4x4 pick-up trucks intended for off-road use, in combination with locking center and rear differentials.