Search results
Results from the WOW.Com Content Network
The primary difference is the lower freezing point of Jet A-1 fuel: [7] Jet A's is −40 °C (−40 °F) Jet A-1's is −47 °C (−53 °F) The other difference is the mandatory addition of an antistatic additive to Jet A-1 fuel. Jet A and Jet A-1 fuel trucks and storage tanks, as well as plumbing that carries them, are all marked "Jet A" or ...
[6]: 63–64 The fueler reported that the density of jet fuel at the time was 1.77, which was in lb/L, since other Air Canada aircraft used lb. Pearson and Quintal both used the density of jet fuel in lb/L without converting to kg/L: [6]: 40–41 7,682 L × 1.77 lb/L = 13,597 lb = misinterpreted as kilograms of fuel already on board
For example, Concorde cruised at 1354 mph, or 7.15 million feet per hour, with its engines giving an SFC of 1.195 lb/(lbf·h) (see below); this means the engines transferred 5.98 million foot pounds per pound of fuel (17.9 MJ/kg), equivalent to an SFC of 0.50 lb/(lbf·h) for a subsonic aircraft flying at 570 mph, which would be better than even ...
Conversions; 1 lb/h = 0.4535927 ... Minimum fuel intake on a jumbo jet can be as low as 150 lb/h (68 kg/h) when idling; however, this is not enough to sustain flight ...
Jet fuel is a clear to straw-colored fuel, based on either an unleaded kerosene (Jet A-1), or a naphtha–kerosene blend (Jet B). Similar to diesel fuel , it can be used in either compression ignition engines or turbine engines .
With a fuel fraction of nearly 85%, the GlobalFlyer could carry 5 times its weight in fuel.. In aerospace engineering, an aircraft's fuel fraction, fuel weight fraction, [1] or a spacecraft's propellant fraction, is the weight of the fuel or propellant divided by the gross take-off weight of the craft (including propellant): [2]
The fuel consumption is an equivalent measure for cars sold outside the United States, typically measured in litres per 100 km traveled; in general, the fuel consumption and miles per gallon would be reciprocals with appropriate conversion factors, but because different countries use different driving cycles to measure fuel consumption, fuel ...
STG+ produces gasoline, diesel, jet fuel and aromatics, depending on the catalysts used. The STG+ technology also incorporates durene reduction into its core process, meaning that the entire fuel production process requires only two steps: syngas production and gas to liquids synthesis. [1]