Search results
Results from the WOW.Com Content Network
On October 7, 2015, the Commercial division of GE Lighting was separated from the business and a new startup, Current, was created. [9] On July 1, 2020, GE Lighting was acquired by Savant Systems, a home automation company headquartered in Hyannis, Massachusetts, United States. [10] This was General Electric's last consumer business. [11]
AC contactor for pump application. A contactor is an electrically controlled switch used for switching an electrical power circuit. [1] A contactor is typically controlled by a circuit which has a much lower power level than the switched circuit, such as a 24-volt coil electromagnet controlling a 230-volt motor switch.
Usually utilization category is mentioned in most of the switch gear, with the above contactor stating to be used under AC1 - resistive load & AC3 for motor usage. In electrical engineering utilization categories are defined by IEC standards [1] and indicate the type of electrical load and duty cycle of the loads to ease selection of contactors ...
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
The 92-acre (370,000 m 2) campus is home to GE's Lighting & Electrical Institute, which was founded in 1933. Each December, Nela Park features a world-famous Christmas lighting display, which culminates in a miniature version of the National Christmas Tree in Washington, D.C. , designed by GE Lighting.
Typical domestic panel circuit breakers are rated to interrupt 6 kA (6000 A) short-circuit current. Miniature circuit breakers used to protect control circuits or small appliances may not have sufficient interrupting capacity to use at a panel board; these circuit breakers are called "supplemental circuit protectors" to distinguish them from ...
Ignitron rectifiers powering industrial process, 1945. An ignitron is usually a large steel container with a pool of mercury in the bottom that acts as a cathode during operation.
The most common machine is the impact riveter and the most common use of semi-tubular rivets is in lighting, brakes, ladders, binders, HVAC duct-work, mechanical products, and electronics. They are offered from 1/16-inch (1.6 mm) to 3/8-inch (9.5 mm) in diameter (other sizes are considered highly special) and can be up to 8 inches (203 mm) long.