enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Faucet aerator - Wikipedia

   en.wikipedia.org/wiki/Faucet_aerator

   A faucet aerator can be classified on the basis of its flow rate and the type of water stream (aerated, non-aerated, spray) it produces. In general, standard-sized aerators are available with female (M22x1) or male threading (M24x1). Bathtub spouts often have a bigger diameter with a male M28x1 thread.

3. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

4. Screwfix - Wikipedia

   en.wikipedia.org/wiki/Screwfix

   Screwfix Direct Limited, trading as Screwfix, is a retailer of trade tools, accessories and hardware products based in the United Kingdom. [6] Founded in 1979 as the Woodscrew Supply Company, the company was acquired in July 1999 by Kingfisher plc , which also owns B&Q , and is listed on the London Stock Exchange .

5. Aerator - Wikipedia

   en.wikipedia.org/wiki/Aerator

   An aerator is a mechanical device used for aeration, or mixing air with another substance, such as water or soil. The word aerator may also refer to: Faucet aerator; Floating surface aerator, used in wastewater treatment; Lawn aerator; Surface or subsurface aerator, used in water aeration; Wine aerator

6. Gender of connectors and fasteners - Wikipedia

   en.wikipedia.org/wiki/Gender_of_connectors_and...

   Schematic symbols for male and female connector pins. In electrical and mechanical trades and manufacturing, each half of a pair of mating connectors or fasteners is conventionally designated as male or female, [1] a distinction referred to as its gender. [2] The female connector is generally a receptacle that receives and holds the male connector.

7. Ground glass joint - Wikipedia

   en.wikipedia.org/wiki/Ground_glass_joint

   Crude versions of conically tapered ground glass joints have been made for quite a while, [1] particularly for stoppers for glass bottles and retorts. [2] Crude glass joints could still be made to seal well by grinding the two parts of a joint against each other using an abrasive grit, but this led to variations between joints and they would not seal well if mated to a different joint.