Search results
Results from the WOW.Com Content Network
For example, one inch measured from a drawing with a scale of "one-inch-to-the-foot" is equivalent to one foot in the real world (a scale of 1:12)....one inch measured from a drawing with a scale of "two-inches-to-the-foot" is equivalent to six inches in the real world (a scale of 1:6). It is not to be confused with a true unitless ratio.
English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.
Also the main Lego scale, known as minifig scale. [13] The rather uncommon [citation needed] 40 mm figure scale wargames figures fit approximately into this scale. 1:45: 6.773 mm This is the scale which MOROP has defined for O scale, because it is half the size of the 1:22.5 Scale G-gauge model railways made by German manufacturers. [citation ...
Two wooden yardsticks with brass ends, in inches and division of yard for half, quarter, eighth and sixteenth A folding metre-stick carpenter's ruler with millimetre divisions and numbers in centimetres. Fully extended it measures 2 metres. In countries in which the metric system is used, the scale typically contains only a metric scale.
The scale can be expressed in four ways: in words (a lexical scale), as a ratio, as a fraction and as a graphical (bar) scale. Thus on an architect's drawing one might read 'one centimeter to one meter', 1:100, 1/100, or 1 / 100 . A bar scale would also normally appear on the drawing.
A ruler with two linear scales: the metric and imperial.It includes shorter minor graduations and longer major graduations. A graduation is a marking used to indicate points on a visual scale, which can be present on a container, a measuring device, or the axes of a line plot, usually one of many along a line or curve, each in the form of short line segments perpendicular to the line or curve.
Models are built to scale, defined as the ratio of any linear dimension of the model to the equivalent dimension on the full-size subject (called the "prototype"), expressed either as a ratio with a colon (ex. 1:8 scale), or as a fraction with a slash (1/8 scale). This designates that 1 inch (or centimeter) on the model represents 8 such units ...
The centimetre (SI symbol: cm) is a unit of length in the metric system equal to 10 −2 metres ( 1 / 100 m = 0.01 m). To help compare different orders of magnitude, this section lists lengths between 10 −2 m and 10 −1 m (1 cm and 1 dm). 1 cm – 10 millimeters; 1 cm – 0.39 inches; 1 cm – edge of a square of area 1 cm 2