Ad
related to: pull up resistor vs down speed calculator image for sale
Search results
Results from the WOW.Com Content Network
A standard TTL input at logic "1" is normally operated assuming a source current of 40 μA, and a voltage level above 2.4 V, allowing a pull-up resistor of no more than 50 kohms; whereas the TTL input at logic "0" will be expected to sink 1.6 mA at a voltage below 0.8 V, requiring a pull-down resistor less than 500 ohms. [2]
All cathodes are connected to the output, which has a pull-down resistor. If any input is high, its diode will be forward-biased and conduct current, and thus pull the output voltage high [b]. If all inputs are low, all diodes will be reverse-biased and so none will conduct current. The pull-down resistor will quickly pull the output voltage low.
Pullup_Resistor.png (222 × 314 pixels, file size: 5 KB, MIME type: image/png) This is a file from the Wikimedia Commons . Information from its description page there is shown below.
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages , bias active elements, and terminate transmission lines , among other uses.
The purpose is to reduce the overall power demand compared to using both a strong pull-up and a strong pull-down. [10] A pure open-drain driver, by comparison, has no pull-up strength except for leakage current: all the pull-up action is on the external termination resistor.
From Wikipedia, the free encyclopedia. Redirect page
If all the input voltages are low (logical "0"), the transistor is cut-off. The pull-down resistor R 1 biases the transistor to the appropriate on-off threshold. The output is inverted since the collector-emitter voltage of transistor Q 1 is taken as output, and is high when the inputs are low. Thus, the analog resistive network and the analog ...
The voltage drop across any resistor depends on the current flowing; in a circuit, currents can change and consequently the voltages at specific points in that circuit may go up at one end of what is called a pull-up resistor, or down at one end of what is called a pull-down resistor. 70.27.152.243 19:57, 20 July 2016 (UTC)
Ad
related to: pull up resistor vs down speed calculator image for sale