Search results
Results from the WOW.Com Content Network
Battery leakage is the escape of chemicals, such as electrolytes, within an electric battery due to generation of pathways to the outside environment caused by factory or design defects, excessive gas generation, or physical damage to the battery.
There are different chemical families of corrosion inhibitors used in the oil industry, among them are the following: Fatty Imidazolines: These are imidazole-based compounds, usually with a long unsaturated chain length, derived mainly from oleic acid. They are very effective in preventing acid corrosion of carbon steel (Figure 1). [5] Figure 1.
In the application of passive cathodic protection, a galvanic anode, a piece of a more electrochemically "active" metal (more negative electrode potential), is attached to the vulnerable metal surface where it is exposed to an electrolyte.
Corrosion monitoring is the use of a corrator (corrosion meter) or set of methods [1] and equipment to provide offline or online information about corrosion rate expressed in mpy (mill per year). [ 2 ] - for better care and to take or improve preventive measures to combat and protect against corrosion .
Aqueous parts cleaning industrial washer. Parts cleaning is a step in various industrial processes, either as preparation for surface finishing or to safeguard delicate components. One such process, electroplating, is particularly sensitive to part cleanliness, as even thin layers of oil can hinder coating adhesion.
The effectiveness of a corrosion inhibitor depends on fluid composition and dynamics. Corrosion inhibitors are common in industry, and also found in over-the-counter products, typically in spray form in combination with a lubricant and sometimes a penetrating oil. They may be added to water to prevent leaching of lead or copper from pipes. [2]
Electropolishing, also known as electrochemical polishing, anodic polishing, or electrolytic polishing (especially in the metallography field), is an electrochemical process that removes material from a metallic workpiece, reducing the surface roughness by levelling micro-peaks and valleys, improving the surface finish.
Before plating, the surface of the material must be thoroughly cleaned. Unwanted solids left on the surface cause poor plating. Cleaning is usually achieved by a series of chemical baths, including non-polar solvents to remove oils and greases, as well as acids and alkalis to remove oxides, insoluble organics, and other surface contaminants.