enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Penny (unit) - Wikipedia

   en.wikipedia.org/wiki/Penny_(unit)

   A larger number indicates a longer nail, shown in the table below. Diameter of the nail also varies based on penny size, depending on nail type. Nails under 1 + 1 ⁄ 4 inch, often called brads, are sold mostly in small packages with only a length designation or with length and wire gauge designations; for example, 1″ 18 ga. or 3 ⁄ 4 ″ 16 ga.

3. Nail (fastener) - Wikipedia

   en.wikipedia.org/wiki/Nail_(fastener)

   Most countries, except the United States, use a metric system for describing nail sizes. A 50 × 3.0 indicates a nail 50 mm long (not including the head) and 3 mm in diameter. Lengths are rounded to the nearest millimetre. For example, finishing nail* sizes typically available from German suppliers are:

4. Nail (unit) - Wikipedia

   en.wikipedia.org/wiki/Nail_(unit)

   The nail was apparently named after the practice of hammering brass nails into the counter at shops where cloth was sold. [2] [3] [4] On the other hand, R D Connor, in The weights and measures of England (p 84) states that the nail was the 16th part of a Roman foot, i.e., digitus or finger, although he provides no reference to support this. [5]

5. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   Due to its design, a single bit can be used for drilling a wide range of hole sizes. Some bits come to a point and are thus self-starting. The larger-size bits have blunt tips and are used for hole enlarging. Unibits are commonly used on sheet metal [11] and in general construction. One drill bit can drill the entire range of holes necessary on ...

6. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ...

7. Brass fastener - Wikipedia

   en.wikipedia.org/wiki/Brass_fastener

   A brass fastener, butterfly clips, brad, paper fastener or split pin is a stationery item used for securing multiple sheets of paper together. A patent of the fastener was issued in 1866 to George W McGill. [ 1 ]