Search results
Results from the WOW.Com Content Network
The symbol is placed on the arrow side or other side of the line to indicate which side of the joint the weld goes. The dimensions and other numbers such as the length of the weld or number of spot welds go above and below the reference line. Supplementary symbols go at the junction of the reference line and the arrow tip. One such symbol is a ...
Welding terms and symbols. Glossary for welding, brazing and thermal cutting BS 499-2C: Welding terms and symbols. European arc welding symbols in chart form BS 2633: Specification for Class I arc welding of ferritic steel pipework for carrying fluids BS 2971: Specification for class II arc welding of carbon steel pipework for carrying fluids ...
An interior or exterior corner, with an angle or type of bevel, is called a "chamfer". Fillet geometry, when on an interior corner is a line of concave function , whereas a fillet on an exterior corner is a line of convex function (in these cases, fillets are typically referred to as rounds).
Making a fillet weld with gas metal arc welding. Fillet welding refers to the process of joining two pieces of metal together when they are perpendicular or at an angle. . These welds are commonly referred to as tee joints, which are two pieces of metal perpendicular to each other, or lap joints, which are two pieces of metal that overlap and are welded at the
Welding joint. In metalworking, a welding joint is a point or edge where two or more pieces of metal or plastic are joined together. They are formed by welding two or more workpieces according to a particular geometry. There are five types of joints referred to by the American Welding Society: butt, corner, edge, lap, and tee. These types may ...
A note that is called out in specific spots in the field of the drawing. It is numbered with a stylized flag symbol surrounding the number. A general note applies generally and is not called out with flags. FL Floor Level Floor Level of an existing or proposed building or concrete pad FN or F/N: flag note, flagnote; find number: 1.
The weld access hole or rat hole is a structural engineering technique in which a part of the web of an I-beam or T-beam is cut out at the end or ends of the beam. The hole in the web allows a welder to weld the flange to another part of the structure with a continuous weld the full width on both top and bottom sides of the flange. Without the ...
The bevel provides a smooth clean edge to the plate or pipe and allows a weld of the correct shape (to prevent center-line cracking) to join the separate pieces of metal. [ citation needed ] Simple bevels can be used with a backup strip (thin removable sheet behind the plate joint) with chamfers (and a small land) being used on open root welds.