Search results
Results from the WOW.Com Content Network
This avoids one of the principal challenges faced by the larger, two-part pumps: maintaining a water-tight seal at the point where the pump drive shaft enters the pump body. Small- to medium-sized circulator pumps are usually supported entirely by the pipe flanges that join them to the rest of the hydronic plumbing. Large pumps are usually pad ...
Watts logo. Watts Water Technologies, Inc. is a company based in the United States that makes valve products for plumbing and heating, such as water pressure regulators and other valves. [1] Watts is one of the largest manufacturers of water valves in the United States. The company was founded by Joseph Watts. [2] It employs about 4,500 ...
GE further developed the BWR-1 design with the 70 MW Big Rock Point (9×9, 11×11, 12×12) reactor, which (like all GE BWR models following Dresden 1) used the more economical direct cycle method of heat transfer, but disposed with the external recirculation pumps in favor of natural circulation (an unusual strategy that only the 55 MW ...
The secondary pump takes the feed water going to the boiler and raises the pressure of the water going in. In a natural circulation boilers, the circulation of water is dependent on the differential pressures caused by the change of density in the water as it is heated. That is to say that as the water is heated and starts turning to steam, the ...
Water reservoir - it is not a part of reciprocating pump, however, it is the main source where from the reciprocating pump takes the water. It may be a source of other fluid as well. Strainer - It removes all impurities from the liquid to avert chocking the pump. Suction Pipe - It is a pipe by which pump takes the water from the reservoir.
The top has a small outlet, usually hidden beneath a plastic dust cap. Internally there is a large hollow body, normally filled with water, and containing a float valve. The valve must always be installed vertically, usually at the top of a short vertical pipe. If the valve body is filled with water, the float moves upwards and closes the valve.
The pump used a leather hose which did not need to self-open when released by the rollers, instead relying on the incoming water having sufficient pressure to fill the open inlet end on each cycle. [1] The peristaltic pump was first patented in the United States by Rufus Porter and J. D. Bradley in 1855 (U.S. Patent number 12753) [2] as a well ...
A means had to be provided, of course, to put the initial charge of water into the boiler (before steam power was available to operate the steam-powered feedwater pump). The pump was often a positive displacement pump that had steam valves and cylinders at one end and feedwater cylinders at the other end; no crankshaft was required.