Search results
Results from the WOW.Com Content Network
In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.
Other ceramic pieces would typically be used as a junction point between the wiring system proper, and the more flexible cloth-clad wiring found in light fixtures or other permanent, hard-wired devices. When a generic power outlet was desired, the wiring could run directly into the junction box through a tube of protective loom and a ceramic ...
[citation needed] A common mnemonic electricians use to remember which wire goes to which terminal is "white to light…black to brass…green to green". [6] Phase wire in a circuit may be any color other than green, gray, or white (whether these are solid colors or stripes). The common colors are black, red, blue, brown, yellow, and orange ...
The cable is terminated on a television outlets, typically an F connector mounted on a face plate. If there are multiple outlets, an RF splitter is used to divide the signal among them; outlets on the splitter are connected to television outlets at each location (living room, rec room, bedrooms, den, for example).
Special outlet and junction boxes were made for lamps and switches, made either of porcelain or sheet steel. The crimped seam was not considered as watertight as the Stannos wire used in England, which had a soldered sheath. [10] A somewhat similar system called "concentric wiring" was introduced in the United States around 1905.
As an example, the 5-15R is the common 125 V two-pole, three-wire receptacle rated for 15 A. The L5-15R, while sharing the same electrical rating, is a locking design that is not physically compatible with the straight-blade 5-15 design. The 5-30R has the same two-pole, three-wire configuration and 125 V rating, but is rated for 30 A.
Shown here will be fastened to this recessed, non-metallic box, then a cover plate is installed. This "double gang" (two unit) installation uses non-metallic-sheathed cable and twist-on wire connectors. In electrical wiring, a light switch is a switch most commonly used to operate electric lights, permanently connected equipment, or electrical ...
Some of these devices used larger undercut screw terminals to more securely hold the wire. Special CO/ALR-rated wall outlet and wall switch. Unfortunately, CU/AL switches and receptacles failed to work well enough with aluminum wire, and a new specification called CO/ALR (meaning copper-aluminum, revised) was created.