Search results
Results from the WOW.Com Content Network
[2] In the United States, common sizes for steel shelf angles include L 3" x 3" x 1/4" and L 4" x 4" x 1/4".In the UK and Europe shelf angles / masonry support are predominantly manufactured in stainless steel to prevent corrosion and failure. These are bespoke to the building's frame and engineered to take the loads required.
(HSS dimensions are based on exterior dimensions of the profile; pipes are also manufactured to an exterior tolerance, albeit to a different standard.) The corners of HSS are heavily rounded, having a radius which is approximately twice the wall thickness. The wall thickness is uniform around the section.
Height of rail equaled width of foot for each ASCE tee-rail weight; and the profiles specified fixed proportion of weight in head, web and foot of 42%, 21% and 37%, respectively. ASCE 90 lb/yd (44.6 kg/m) profile was adequate; but heavier weights were less satisfactory.
The older United States Standard Gauge is based upon 40 lb per square foot per inch thick. Gauge is defined differently for ferrous (iron-based) and non-ferrous metals (e.g. aluminium and brass). The gauge thicknesses shown in column 2 (U.S. standard sheet and plate iron and steel decimal inch (mm)) seem somewhat arbitrary.
Knuckle threads with a flat 30 degree flank thread angle are standardized in DIN 405 for inch pitches and diameters ranging from 8 mm to 200 mm. [3] A more recent standard DIN 20400 uses metric thread pitch and lists diameters from 10 mm to 300 mm. [4] As DIN is a German organization, many instances of the DIN thread charts [5] write numbers with a comma as the decimal marker.
Lead angle is 90° to the helix angle between the helical tooth face and an equivalent spur tooth face. For the same lead, the lead angle is larger for smaller gear diameters. It is understood to be measured at the standard pitch diameter unless otherwise specified. A spur gear tooth has a lead angle of 90°, and a helix angle of 0°. See ...
This page was last edited on 30 June 2012, at 11:33 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may ...
The larger connector sizes are the most varied, with designated connectors ranging from analog and digital signals to AC and DC power. [4] Each "coding" has a different keyway that prevents incorrect connection between incompatibly keyed connectors. [5]