enow.com Web Search

  1. Ads

    related to: ge front loader won't spin away top gear

Search results

  1. Results from the WOW.Com Content Network
  2. List of GE locomotives - Wikipedia

    en.wikipedia.org/wiki/List_of_GE_locomotives

    * Note: two versions: one contained a 16-cylinder 7HDL, co-developed by GE and the German firm Deutz-MWM, rated at 6000 HP; the other a 16-cylinder 7FDL rated at 4390 HP. The units equipped with the 7FDL were a sub-version AC6000 "Convertible" and were produced to get the type into operation while the 7HDL was developed.

  3. GE 44-ton switcher - Wikipedia

    en.wikipedia.org/wiki/GE_44-ton_switcher

    The GE 44-ton switcher is a four-axle diesel-electric locomotive built by General Electric between 1940 and 1956. It was designed for industrial and light switching duties, often replacing steam locomotives that had previously been assigned these chores.

  4. GE 45-ton switcher - Wikipedia

    en.wikipedia.org/wiki/GE_45-ton_switcher

    The GE 45-ton was extremely versatile and many variants existed. It has a high weight to power ratio and has excellent traction, rated to be able to pull 20 loaded freight cars on level track. They were built with a short wheelbase for use in industrial plants, yards, and other places where clearances were tight.

  5. Locomotive wheelslip - Wikipedia

    en.wikipedia.org/wiki/Locomotive_wheelslip

    The greatest effort is required from a locomotive when starting. At this time, if the engineer applies too much power to the wheels (i.e., for a steam locomotive, the engineer opens the regulator too far) the turning force applied to the wheel will greatly exceed the opposing friction force affected by the surface of the rail, and the wheel will turn without being able to move the train forward.

  6. Diesel engine runaway - Wikipedia

    en.wikipedia.org/wiki/Diesel_engine_runaway

    Diesel engine runaway is an occurrence in diesel engines, in which the engine draws extra fuel from an unintended source and overspeeds at higher and higher RPM, producing up to ten times the engine's rated output until destroyed by mechanical failure or bearing seizure due to a lack of lubrication. [1]

  7. Float shifting - Wikipedia

    en.wikipedia.org/wiki/Float_shifting

    Float shifting can reduce clutch wear because it is used so much less (only for starting from a standstill). Conversely, improper engagement of a gear (when the engine and transmission speeds aren't matched) can cause wear on the synchros and lockouts, and damage the gears by physically grinding them together due to a difference in speed.

  8. Differential (mechanical device) - Wikipedia

    en.wikipedia.org/wiki/Differential_(mechanical...

    The left sun gear (red) provides more resistance than the right sun gear (yellow), which causes the planet gear (green) to rotate anti-clockwise. This produces slower rotation in the left sun gear and faster rotation in the right sun gear, resulting in the car's right wheel turning faster (and thus travelling farther) than the left wheel.

  9. Wheelspin - Wikipedia

    en.wikipedia.org/wiki/Wheelspin

    Wheelspin can also occur when changing gears while the vehicle is in motion, as the inertia of the engine and flywheel rotating at a higher rate than the next highest gear tries to bring the input shaft of the transmission to the same speed. This is known commonly as lift-off oversteer.

  1. Ads

    related to: ge front loader won't spin away top gear