Search results
Results from the WOW.Com Content Network
An IEEE 1284 36-pin male micro ribbon printer cable connection. The computer side normally uses a DB-25 port instead of this connector. IEEE 1284, also known as the Centronics port, is a standard that defines bi-directional parallel communications between computers and other devices.
When IBM implemented the parallel interface on the IBM PC, they used the DB-25F connector at the PC-end of the interface, creating the now familiar parallel cable with a DB25M at one end and a 36-pin micro ribbon connector at the other. In theory, the Centronics port could transfer data as rapidly as 75,000 characters per second.
This size, with 36 pins and bail locks, is also known as a Centronics connector because of its introduction by Centronics for use with the parallel port of printers, and is standardized as IEEE 1284 type B. Other connectors of this size are also called Centronics connectors. The smaller size has 0.050 inch (1.27 mm) pitch.
Parallel (Centronics/IEEE 1284) EPP (Enhanced Parallel Port) 16 Mbit/s: 2 MB/s: 1992 Parallel (Centronics/IEEE 1284) ECP (Extended Capability Port) 20 Mbit/s: 2.5 MB/s: 1994 Serial EIA-485 max. 35 Mbit/s: 4.375 MB/s: GPIB/HPIB (IEEE-488.1-2003) IEEE-488 max. 64 Mbit/s: 8 MB/s: FireWire (IEEE 1394) 100: 98.304 Mbit/s: 12.288 MB/s: 1995 FireWire ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
However, parallel lines have lower latency than serial lines, this makes parallel lines is still used on memory bus like DDR SDRAM. Cable length or link length: Crosstalk creates interference between the parallel lines, and the effect worsens with the length of the communication link. This places an upper limit on the length of a parallel data ...
In some cases, though, the host adapter end of the cable would use a different connector. For example, in the Sun 260 series chassis (used for the Sun 3/260 and Sun 4/260 computers), the connector was the same 3-row 96-pin connector used to attach peripheral cards to the VMEbus backplane .
The PIA is designed for glueless connection to the Motorola 6800 style bus, and provides 20 I/O lines, which are organised into two 8-bit bidirectional ports (or 16 general-purpose I/O lines) and 4 control lines (for handshaking and interrupt generation). The directions for all 16 general lines (PA0-7, PB0-7) can be programmed independently.