Search results
Results from the WOW.Com Content Network
Buffer capacity rises to a local maximum at pH = pK a. The height of this peak depends on the value of pK a. Buffer capacity is negligible when the concentration [HA] of buffering agent is very small and increases with increasing concentration of the buffering agent. [3] Some authors show only this region in graphs of buffer capacity. [2]
Buffering HF with NH 4 F results in a solution with a more stable pH; thus, more stable concentrations of HF and HF − 2, and a more stable etch rate. [2] Some oxides produce insoluble products in HF solutions. Thus, HCl may be added to BHF solutions in order to dissolve these insoluble products and produce a higher quality etch. [3]
The term quad buffering is the use of double buffering for each of the left and right eye images in stereoscopic implementations, thus four buffers total (if triple buffering was used then there would be six buffers). The command to swap or copy the buffer typically applies to both pairs at once, so at no time does one eye see an older image ...
Phosphate-buffered saline (PBS) is a buffer solution (pH ~ 7.4) commonly used in biological research. It is a water-based salt solution containing disodium hydrogen phosphate, sodium chloride and, in some formulations, potassium chloride and potassium dihydrogen phosphate. The buffer helps to maintain a constant pH.
Good's buffers (also Good buffers) are twenty buffering agents for biochemical and biological research selected and described by Norman Good and colleagues during 1966–1980. [ 1 ] [ 2 ] [ 3 ] Most of the buffers were new zwitterionic compounds prepared and tested by Good and coworkers for the first time, though some ( MES , ADA , BES , Bicine ...
Bis-tris propane, or 1,3-bis(tris(hydroxymethyl)methylamino)propane, also known as BTP, is a chemical substance that is used in buffer solutions. It is a white to off-white crystalline powder that is soluble in water. It has a wide buffering range, from 6 to 9.5 due to its two pK a values which are close in value.
In a buffer, a weak acid and its conjugate base (in the form of a salt), or a weak base and its conjugate acid, are used in order to limit the pH change during a titration process. Buffers have both organic and non-organic chemical applications. For example, besides buffers being used in lab processes, human blood acts as a buffer to maintain pH.
It is a common observation that when oil and water are poured into the same container, they separate into two phases or layers, because they are immiscible.In general, aqueous (or water-based) solutions, being polar, are immiscible with non-polar organic solvents (cooking oil, chloroform, toluene, hexane etc.) and form a two-phase system.