Search results
Results from the WOW.Com Content Network
A microstrip antenna array for a satellite television receiver Diagram of the feed structure of a microstrip antenna array. In telecommunication, a microstrip antenna (also known as a printed antenna) usually is an antenna fabricated using photolithographic techniques on a printed circuit board (PCB). [1] It is a kind of internal antenna.
As the length of an antenna is made shorter than its fundamental resonant length (a half-wavelength for a dipole antenna and a quarter-wavelength for a monopole), the radiation resistance the antenna presents to the feedline decreases with the square of the electrical length, that is the ratio of physical length to wavelength, (/). As a result ...
the upper half of a vertical full-wavelength loop antenna mounted on the ground (not to be confused with the visually similar but electrically different half-square antenna described below, under array antennas, [u] nor to be confused with the halo antenna, described next). The full loop is cut at two opposite points along its perimeter, and ...
Stubs can match a load impedance to the transmission line characteristic impedance. The stub is positioned a distance from the load. This distance is chosen so that at that point, the resistive part of the load impedance is made equal to the resistive part of the characteristic impedance by impedance transformer action of the length of the main ...
The first technique developed was the far-field range, where the antenna under test (AUT) is placed in the far-field of a range antenna. Due to the size required to create a far-field range for large antennas, near-field techniques were developed, which allow the measurement of the field on a distance close to the antenna (typically 3 to 10 ...
A patch antenna is a type of antenna with a low profile, usually consisting of a printed circuit board. It consists of a planar rectangular or circular sheet or "patch" of metal, mounted over a larger sheet of metal called a ground plane. It is the original type of microstrip antenna described by Howell in 1972. [1]
The Smith chart (sometimes also called Smith diagram, Mizuhashi chart (水橋チャート), Mizuhashi–Smith chart (水橋スミスチャート), [1] [2] [3] Volpert–Smith chart (Диаграмма Вольперта—Смита) [4] [5] or Mizuhashi–Volpert–Smith chart) is a graphical calculator or nomogram designed for electrical and electronics engineers specializing in radio ...
AT&T 2 wire rhombic in Dixon, California, in 1937, used for telephone service to Shanghai, China. The rhombic antenna was designed in 1931 by Edmond Bruce [1] and Harald Friis, [2] [3] It was mostly commonly used in the high frequency (HF) or shortwave band as a broadband directional antenna.