Search results
Results from the WOW.Com Content Network
A deep foundation is a type of foundation that transfers building loads to the earth farther down from the surface than a shallow foundation does to a subsurface layer or a range of depths. A pile or piling is a vertical structural element of a deep foundation, driven or drilled deep into the ground at the building site .
Schematic cross section of a pressurized caisson. In geotechnical engineering, a caisson (/ ˈ k eɪ s ən,-s ɒ n /; borrowed from French caisson 'box', from Italian cassone 'large box', an augmentative of cassa) is a watertight retaining structure [1] used, for example, to work on the foundations of a bridge pier, for the construction of a concrete dam, [2] or for the repair of ships.
Thermal Integrity Profiling (TIP) is a non-destructive testing method used to evaluate the integrity of concrete foundations. It is standardized by ASTM D7949 - Standard Test Methods for Thermal Integrity Profiling of Concrete Deep Foundations. The testing method was first developed in the mid 1990s at the University of South Florida.
High strain dynamic testing is a method of testing deep foundations to obtain information about their capacity and integrity, and in some cases, to monitor their installation. It is codified by ASTM D4945-12 - Standard Test Method for High-Strain Dynamic Testing of Piles.
A part's-eye view of a boring bar. Hole types: Blind hole (left), through hole (middle), interrupted hole (right). In machining, boring is the process of enlarging a hole that has already been drilled (or cast) by means of a single-point cutting tool (or of a boring head containing several such tools), such as in boring a gun barrel or an engine cylinder.
In the oil and gas industry the operator will likely require a set of samples for further analysis in their labs. Many national regulations stipulate that for any well drilled, a set of samples must be archived with a national body. For example, in the case of the UK with the British Geological Survey . The bulk of the cuttings require disposal.
Before shaft alignment can be done, the foundations for the driver and the driven piece must be designed and installed correctly. [citation needed]Flexible couplings are designed to allow a driver (e.g., electric motor, engine, turbine, hydraulic motor) to be connected to the driven equipment.
A shaft equipped with ladder rungs for personnel access. In civil engineering a shaft is an underground vertical or inclined passageway. Shafts are often entered through a manhole and closed by a manhole cover. They are constructed for a number of reasons including: For the construction of a tunnel