Search results
Results from the WOW.Com Content Network
Many other materials are used to meet lightweighting goals. [12] Cost of lightweighting, and increasingly sustainability of materials, is becoming an issue in solution selection - with the viable cost increase of a part per kilogram saved being between $5 and $15, [13] depending on the price point and performance needs of the vehicle.
The main advantages of a pull-rod suspension system on a track-focused race car have to do primarily with the ability to move suspension components closer to the ground, lower the chassis of the vehicle, and lower the centre of gravity to improve efficiency in cornering, body-roll, and high-speed stability. [2] [7]
John Barnard tried to incorporate this material in a gear housing for the Ferrari F1 car in 1994, but instead only mounted the metal gear case on a carbon fiber composite support. Since then several F1 teams including both Honda (née B.A.R ) and McLaren have raced 'Carbon' cases with substantial composite content.
The European Commission funded a research project, C 3 HARME, under the NMP-19-2015 call of Framework Programmes for Research and Technological Development in 2016-2020 for the design, manufacturing and testing of a new class of ultra-refractory ceramic matrix composites reinforced with silicon carbide fibers and Carbon fibers suitable for applications in severe aerospace environments.
In addition, lowering the centre of gravity will always help the handling (as well as reduce the chance of roll-over). This can be done to some extent by using plastic windows (or none) and light roof, hood (bonnet) and boot (trunk) lid materials, by reducing the ground clearance, etc. Increasing the track with "reversed" wheels will have a similar effect, but remember that the wider the car ...
Ultralight materials are solids with a density of less than 10 mg/cm 3, including silica aerogels, carbon nanotube aerogels, aerographite, metallic foams, polymeric foams, and metallic microlattices. The density of air is about 1.275 mg/cm 3 , which means that the air in the pores contributes significantly to the density of these materials in ...
[citation needed] This gives the front tires an advantage in overcoming the car's moment of inertia (yaw angular inertia), thus reducing corner-entry understeer. Using wheels and tires of different sizes (proportional to the weight carried by each end) is a lever automakers can use to fine tune the resulting over/understeer characteristics.
Unsprung mass is a consideration in the design of a vehicle's suspension and the materials chosen for its components. Beam axle suspensions, in which wheels on opposite sides are connected as a rigid unit, generally have greater unsprung mass than independent suspension systems, in which the wheels are suspended and allowed to move separately.