Search results
Results from the WOW.Com Content Network
A diagram of a traditional French drain. A French drain [1] (also known by other names including trench drain, blind drain, [1] rubble drain, [1] and rock drain [1]) is a trench filled with gravel or rock, or both, with or without a perforated pipe that redirects surface water and groundwater away from an area.
CIPP is considered a trenchless technology, meaning little to no digging is typically required, for a potentially more cost-effective and less disruptive method than traditional "dig and replace" pipe repair methods. The liner is inserted using water or air pressure, applied via pressure vessels, scaffolds or a "chip unit".
The reaction is exothermic, releasing heat to soften the fats. Drain cleaners can also contain aluminum, which reacts with sodium hydroxide to produce bubbles of hydrogen gas that help to break up the clog. [11] The pressure buildup by gas generation can cause weaker pipes to burst, [11] and the heat generation can also soften plastic PVC pipes.
Most municipal building codes mandate that drain plumbing increase in diameter as it moves closer to the municipal sewer system. i.e., most kitchen sinks evacuate water with a 1 + 1 ⁄ 2-inch drain pipe, which feeds into a larger 4-inch drain pipe on the main plumbing stack before heading to a septic tank or to the city sewage system. This ...
A water pipe is a pipe or tube, frequently made of plastic or metal, [a] that carries pressurized and treated fresh water to a building (as part of a municipal water system), as well as inside the building.
Vitrified clay pipe (VCP) is pipe made from a blend of clay and shale that has been subjected to high temperature to achieve vitrification, which results in a hard, inert ceramic. VCP is commonly used in gravity sewer collection mains because of its long life and resistance to almost all domestic and industrial sewage , particularly the ...
A pipe laser, or another vertical distance measuring device is most commonly used for this. Invert levels are important for the drainage of a non-pressured fluid pipe. Typically, a good design requires that the invert level of the pipe will be lower (or at least not higher) for each section of pipe before it reaches its final destination. [5]
The heyday of the clog in Britain was between the 1840s and 1920s and, although traditionally associated with Lancashire, they were worn all over the country, not just in the industrial North of England. [3] [4] Indeed, Mark Clyndes of Walkleys says "More clogs were worn down south than in the northern industrial towns". [5]