Search results
Results from the WOW.Com Content Network
powercfg must be run from an elevated command prompt, and, under Windows XP, it requires workstation Administrator or power user rights. Power Schemes are configured on a per-user basis. The most common cause of problems with power saving and hibernation on Windows systems is an incompatible device driver.
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring.
For example, in the x86 architecture, asserting the RESET line halts the CPU; this is done after the system is switched on and before the power supply has asserted "power good" to indicate that it is ready to supply stable voltages at sufficient power levels. [2] Reset places less stress on the hardware than power cycling, as the power is not ...
The first memory location the CPU tries to execute is known as the reset vector. In the case of a hard reboot, the northbridge will direct a code fetch request to the BIOS located on the system flash memory. For a warm boot, the BIOS will be located in the proper place in RAM and the northbridge will direct the reset vector call to the RAM. In ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Start/Stop Count A tally of spindle start/stop cycles. The spindle turns on, and hence the count is increased, both when the hard disk is turned on after having before been turned entirely off (disconnected from power source) and when the hard disk returns from having previously been put to sleep mode .
Walmart CFO John David Rainey told Yahoo Finance on Tuesday it has seen a brisk start to the season. Target stock was up 9% year to date ahead of the results, lagging the S&P 500's 24% advance ...
Low Pin Count interface Winbond chip Trusted Platform Module installed on a motherboard, and using the LPC bus. The Low Pin Count (LPC) bus is a computer bus used on IBM-compatible personal computers to connect low-bandwidth devices to the CPU, such as the BIOS ROM (BIOS ROM was moved to the Serial Peripheral Interface (SPI) bus in 2006 [1]), "legacy" I/O devices (integrated into Super I/O ...