Search results
Results from the WOW.Com Content Network
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
A push-button (also spelled pushbutton) or simply button is a simple switch mechanism to control some aspect of a machine or a process. Buttons are typically made out of hard material, usually plastic or metal. [1] The surface is usually flat or shaped to accommodate the human finger or hand, so as to be easily depressed or pushed.
A detent is a mechanical or magnetic means to resist or arrest the movement of a mechanical device. [1] Such a device can be anything ranging from a simple metal pin to a machine. The term is also used for the method involved. Magnetic detents are most often used to divide a shaft rotation into discrete increments.
A potentiometer was often used to adjust "vertical hold", which affected the synchronization between the receiver's internal sweep circuit (sometimes a multivibrator) and the received picture signal, along with other things such as audio-video carrier offset, tuning frequency (for push-button sets) and so on. It also helps in frequency ...
Thus a meter with a 50 μA movement will have a "sensitivity" of 20,000 Ω/V. "Per volt" refers to the fact that the impedance the meter presents to the circuit under test will be 20,000 Ω multiplied by the full-scale voltage to which the meter is set. For example, if the meter is set to a range of 300 V full scale, the meter's impedance will ...
Ladder logic was originally a written method to document the design and construction of relay racks as used in manufacturing and process control. [1] Each device in the relay rack would be represented by a symbol on the ladder diagram with connections between those devices shown.
In American English, a set screw is a screw that is used to secure an object, by pressure and/or friction, within or against another object, such as fixing a pulley or gear to a shaft. [ 1 ] [ 2 ] A set screw is normally used without a nut (which distinguishes it from a bolt ), being screwed instead in a threaded hole drilled in only one of the ...
Each key of a computer keyboard, for example, is a normally-open "push-to-make" switch. A "push-to-break" (or normally-closed or NC) switch, on the other hand, breaks contact when the button is pressed and makes contact when it is released. An example of a push-to-break switch is a button used to release a door held closed by an electromagnet.