Ad
related to: yield strength of aluminum alloys table
Search results
Results from the WOW.Com Content Network
T6 temper 6061 has been treated to provide the maximum precipitation hardening (and therefore maximum yield strength) for a 6061 aluminium alloy. It has an ultimate tensile strength of at least 290 MPa (42 ksi) and yield strength of at least 240 MPa (35 ksi). More typical values are 310 MPa (45 ksi) and 270 MPa (39 ksi), respectively. [10]
2024-O temper aluminium has no heat treating. It has an ultimate tensile strength of 140–210 MPa (21–30 ksi), and a maximum yield strength of no more than 97 MPa (14,000 psi). The material has elongation (stretch before ultimate failure) of 10–25%, this is the allowable range per applicable AMS specifications.
Cast aluminium alloys yield cost-effective products due to the low melting point, although they generally have lower tensile strengths than wrought alloys. The most important cast aluminium alloy system is Al–Si, where the high levels of silicon (4–13%) contribute to give good casting characteristics. Aluminium alloys are widely used in ...
6 Aluminum alloy table. Toggle the table of contents. ... (16,000 psi) from 13 to 25 mm (0.5 to 1 in) thick, and yield strength of at least 62 MPa (9,000 psi) in ...
6082 aluminium alloy is an alloy in the wrought aluminium-magnesium-silicon family (6000 or 6xxx series). It is one of the more popular alloys in its series (alongside alloys 6005 , 6061 , and 6063 ), although it is not strongly featured in ASTM (North American) standards.
9 Aluminum alloy table. ... Aluminium 7050 alloy is a heat treatable alloy. It has high toughness, high strength. ... Yield strength 455 MPa Fatigue strength 240 MPa ...
Yield strength: 520 MPa Elongation at break: 6% Poisson's ratio: 0.34 ... Aluminium alloy table References. This page was last edited on 8 April 2024, at ...
4 Aluminium alloy table. 5 References. Toggle the table of contents. 2017 aluminium alloy. ... Yield strength (annealed) 69 MPa Elongation (annealed) 22% Elastic modulus:
Ad
related to: yield strength of aluminum alloys table