Search results
Results from the WOW.Com Content Network
The test cartridge must be inserted into the chamber in such a way that the hole in the test cartridge case lines up with a gas port hole that channels the gas pressure from the cartridge case to the face of the sensor. The measurement accuracy of the pressure measurements with 21st century high-pressure sensors is expected to be ≤ 2%. [7]
Horst, Albert W. (November 2005), A Brief Journey Through the History of Gun Propulsion, Aberdeen Proving Ground, MD: United States Army Research Laboratory, ARL-TR-3671; Mader, Charles L. (2008), Numerical Modeling of Explosives and Propellants (3rd ed.), CRC Press, ISBN 978-1-4200-5238-1; A (Very) Short Course in Internal Ballistics, Fr. Frog
The velocity of detonation is an important indicator for overall energy and power of detonation, and in particular for the brisance or shattering effect of an explosive which is due to the detonation pressure. The pressure can be calculated using Chapman-Jouguet theory from the velocity and density.
This method is fine for getting a good estimate regarding bolt thrust and assumes an overly large area that the gas pressure acts against yielding pessimistic estimations, generating a safety margin in the process for worse case scenarios which can result in increased maximum (peak) chamber pressure of the firearms cartridge, like a round that ...
Obturation is the necessary barrel blockage or fit in a firearm or airgun created by a deformed soft projectile. [1] A bullet or pellet made of soft material and often with a concave base will flare under the heat and pressure of firing, filling the bore and engaging the barrel's rifling.
While CUP and LUP numbers were intended to be comparable to the crushing power of a given pressure in psi (lbf/in 2), the numbers are not equivalent.Since a longer duration, lower pressure pulse can crush the cylinder as much as a shorter duration, higher pressure pulse, CUP and LUP pressures frequently register lower than actual peak pressures (as measured by a transducer) by up to 20%.
Within firearms, chamber pressure is the pressure exerted by a cartridge case's outside walls on the inside of a firearm's chamber when the cartridge is fired. The SI unit for chamber pressure is the megapascal (MPa), while the American SAAMI uses the pound per square inch (psi, symbol lbf/in 2) and the European CIP uses bar (1 bar is equal to 0.1 MPa).
Speer Gold Dot 124gr 9mm+P in SIG P226 magazines. Overpressure ammunition, commonly designated as +P or +P+ (pronounced Plus-P or Plus-P-Plus), is small arms ammunition that has been loaded to produce a higher internal pressure when fired than is standard for ammunition of its caliber (see internal ballistics), but less than the pressures generated by a proof round.