Search results
Results from the WOW.Com Content Network
A hook is a hand tool used for securing and moving loads. It consists of a round wooden handle with a strong metal hook about 20 cm (8 inches) long projecting at a right angle from the center of the handle. The appliance is held in a closed fist with the hook projecting between two fingers.
A billhook or bill hook [a] is a versatile cutting tool used widely in agriculture and forestry for cutting woody material such as shrubs, small trees and branches. It is distinct from the sickle . It was commonly used in Europe with an important variety of traditional local patterns.
Wedge — an unsharpened blade for digging, breaking and prying. A San Angelo bar has a wedge at one end. Chisel — a sharpened blade for cutting roots, digging and prying. A pinch point bar has a chisel at one end. Bars are typically 5 to 6 ft (1.5 to 1.8 m) long and weigh 15 to 23 lb (6.8 to 10.4 kg).
The head of a diagonal-peen hammer, as the name implies, has a wedge set at a 45° angle from the handle; it can be a left angle or a right angle, and some peen hammers have a double diagonal wedge [3] for ergonomic reasons. [7] They are commonly used by blacksmiths during the forging process to deliver blows for forging or to strike other ...
A crowbar with a curved chisel end to provide a fulcrum for leverage and a goose neck to pull nails. A crowbar, also called a wrecking bar, pry bar or prybar, pinch-bar, or occasionally a prise bar or prisebar, colloquially gooseneck, or pig bar, or in Australia a jemmy, [1] is a lever consisting of a metal bar with a single curved end and flattened points, used to force two objects apart or ...
The search engine that helps you find exactly what you're looking for. Find the most relevant information, video, images, and answers from all across the Web.
The clamp is opened to insert the tool and then tightened down against the tool to secure it. This type of tap wrench is used with larger taps and where there is room to turn a larger wrench. [1] A T-handle is more compact. This type of wrench uses a collet to secure the tool. The collet design has two pieces: a threaded "nosecap" and four ...
They were set either by sliding a wedge, or later by twisting the handle, which turned a screw, narrowing or widening the jaws. In 1840, Loring Coes , a knife manufacturer in Worcester , Massachusetts, invented a screw-based coach wrench design in which the jaw width was set with a spinning ring fixed under the sliding lower jaw, above the handle.