enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. JST connector - Wikipedia

    en.wikipedia.org/wiki/JST_connector

    It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.

  3. Coaxial power connector - Wikipedia

    en.wikipedia.org/wiki/Coaxial_power_connector

    There are a number of sizes listed below that appear to be quite similar, and while the tolerances of these connectors are typically indicated as ±0.05 or ±0.03 mm by the manufacturers, there is still ambiguity as to whether two sizes differing by only 0.05 mm (or where the specification is only given to the nearest 0.10 mm) warrants listing ...

  4. Crimp (joining) - Wikipedia

    en.wikipedia.org/wiki/Crimp_(joining)

    An electrical crimp is a type of solderless electrical connection which uses physical pressure to join the contacts. Crimp connectors are typically used to terminate stranded wire. [4] Stripped wire is inserted through the correctly sized opening of the connector, and a crimper is used to tightly squeeze the opening against the wire.

  5. IEC 60309 - Wikipedia

    en.wikipedia.org/wiki/IEC_60309

    The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.

  6. IEC metric screw sized connectors - Wikipedia

    en.wikipedia.org/wiki/IEC_metric_screw_sized...

    IEC metric screw sized connectors is a family of electrical connectors defined by IEC that are named according to their ISO metric screw thread, namely M5, M8 and M12. [1] The number gives their outer screw thread diameter in millimeters as with the identically named screws.

  7. Breadboard - Wikipedia

    en.wikipedia.org/wiki/Breadboard

    The adapter is then plugged into the breadboard via the 0.1 in (2.54 mm) connectors. However, the need to solder the components onto the adapter negates some of the advantage of using a solderless breadboard. Very complex circuits can become unmanageable on a solderless breadboard due to the large amount of wiring required.

  8. Electrical connector - Wikipedia

    en.wikipedia.org/wiki/Electrical_connector

    Crimped connectors are a type of solderless connection, using mechanical friction and uniform deformation to secure a connector to a pre-stripped wire (usually stranded). [1] Crimping is used in splice connectors, crimped multipin plugs and sockets, and crimped coaxial connectors. Crimping usually requires a specialised crimping tool, but the ...

  9. U.S. Military connector specifications - Wikipedia

    en.wikipedia.org/wiki/U.S._Military_connector...

    A MIL-DTL-38999 circular connector plated with a nickel–teflon composite. Left: plug (male) type connector; Right: receptacle (female) type connector) Electrical or fiber-optic connectors used by U.S. Department of Defense were originally developed in the 1930s for severe aeronautical and tactical service applications, and the Type "AN" series set the standard for modern military circular ...