enow.com Web Search

  1. Ads

    related to: maximum stud spacing for drywall trim molding ceiling

Search results

  1. Results from the WOW.Com Content Network
  2. Wall stud - Wikipedia

    en.wikipedia.org/wiki/Wall_stud

    trimmer or jack − stud to the left or right of a window or door that runs from the bottom plate to the underside of a lintel or header; cripple stud – a stud located either above or below a framed opening, that does not run the full height of the wall; post or column − a doubled or other integral multiple of a group of studs nailed side ...

  3. Trimmer (construction) - Wikipedia

    en.wikipedia.org/wiki/Trimmer_(construction)

    Trimmers are installed parallel to the primary floor or ceiling joists and support headers, which run perpendicular to the primary joists. [1] [2] It can also refer to a jack stud that supports a header above a window or door opening. Traditionally, a stud which was less than full length was sometimes referred to as a cripple. [3] [4] [5]

  4. Close studding - Wikipedia

    en.wikipedia.org/wiki/Close_studding

    Although close studding is defined by the distance between the vertical timbers, the spacing used is variable, up to a maximum of around 2 feet (600 mm). [2] Studs can either span the full height of the storey or be divided by a middle (or intermediate) rail. To give the frame stability, some form of diagonal bracing is required. [2]

  5. Framing (construction) - Wikipedia

    en.wikipedia.org/wiki/Framing_(construction)

    Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]

  6. Drywall - Wikipedia

    en.wikipedia.org/wiki/Drywall

    Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...

  7. This Hack Will Ensure You ALWAYS Hit A Stud - AOL

    www.aol.com/lifestyle/hack-ensure-always-hit...

    The stud is simply a vertical two-by-four beam in the wall for structural support. And if you lost your stud finder in the moving boxes or simply don’t have one to begin with, these hacks will help.

  1. Ads

    related to: maximum stud spacing for drywall trim molding ceiling