enow.com Web Search

  1. Ads

    related to: furnace starts then stops again when trying to turn signal warning

Search results

  1. Results from the WOW.Com Content Network
  2. Is It Time for a Furnace Upgrade? 10 Warning Signs to ... - AOL

    www.aol.com/time-furnace-upgrade-10-warning...

    Depending on the problem and the age of the furnace, it may be more cost-effective to invest in a replacement furnace instead of making expensive repairs to an old system. 10. Visible Signs of ...

  3. Flame detector - Wikipedia

    en.wikipedia.org/wiki/Flame_detector

    A flame detector is a sensor designed to detect and respond to the presence of a flame or fire, allowing flame detection.Responses to a detected flame depend on the installation, but can include sounding an alarm, deactivating a fuel line (such as a propane or a natural gas line), and activating a fire suppression system.

  4. Forced-air gas - Wikipedia

    en.wikipedia.org/wiki/Forced-air_gas

    Older furnaces sometimes relied on gravity instead of a blower to circulate air. [1]Gas-fired forced-air furnaces have a burner in the furnace fueled by natural gas.A blower forces cold air through a heat exchanger and then through duct-work that distributes the hot air through the building. [2]

  5. Control system - Wikipedia

    en.wikipedia.org/wiki/Control_system

    The rules of the system are written in natural language and translated into fuzzy logic. For example, the design for a furnace would start with: "If the temperature is too high, reduce the fuel to the furnace. If the temperature is too low, increase the fuel to the furnace."

  6. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  7. Thermostat - Wikipedia

    en.wikipedia.org/wiki/Thermostat

    This is the same as "COR" ("close on rise"). May be used to start a fan when it is becoming hot, and to stop the fan when it has become cold enough. "NC" stands for "normally closed". This is the same as "OOR" ("open on rise"). May be used to start a heater when it is becoming cold, and to stop the heater when it has become warm enough.

  1. Ads

    related to: furnace starts then stops again when trying to turn signal warning