enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Faucet aerator - Wikipedia

   en.wikipedia.org/wiki/Faucet_aerator

   An aerator attached to a sink tap. A faucet aerator (or tap aerator) is often found at the tip of modern indoor water faucets.Aerators can simply be screwed onto the faucet head, creating a non-splashing stream and often delivering a mixture of water and air.

3. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size. The same connection method is used for a ballcock. The term tap is widely used to describe the valve used to dispense draft beer from a keg, whether gravity feed or ...

4. The Home Depot Pro - Wikipedia

   en.wikipedia.org/wiki/The_Home_Depot_Pro

   The Home Depot Pro, headquartered in Jacksonville, Florida, is a wholesale distributor and direct marketer of maintenance, repair and operations (MRO) products for ...

5. Aikenhead's Hardware - Wikipedia

   en.wikipedia.org/wiki/Aikenhead's_Hardware

   In 1971 the Aikenhead family sold their chain to Molson, which later started a warehouse in 1991 to head off American chain The Home Depot. Molson sold their 75% stake to Home Depot in 1994, and it became the Canadian unit. [3] (Molson exited the hardware business with the sale of Beaver Lumber in 1999 to Home Hardware. Molson had acquired a ...

6. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   Self-tapping screws can be divided into two classes: [3] those that displace material (especially plastic and thin metal sheets) without removing it, known as "thread-forming" self-tapping screws, and self-tappers with sharp cutting surfaces that remove the material as they are inserted, termed "thread-cutting" self-tapping screws.

7. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   The three taps in the image illustrate the basic types commonly used by most machinists: Bottoming tap The tap illustrated in the top of the image has a continuous cutting edge with almost no taper — between 1 and 1.5 threads of taper is typical. [2] [3] This feature enables a bottoming tap to cut threads to the bottom of a blind hole. A ...