Search results
Results from the WOW.Com Content Network
An electrostatic fieldmeter, also called a static meter is a tool used in the static control industry. It is used for non-contact measurement of electrostatic charge on an object. It measures the force between the induced charges in a sensor and the charge present on the surface of an object.
Coulometry is the measure of charge, thus named after its unit the coulomb. Michael Faraday, known for his work in electricity and magnetism, made critical contributions to the field of electrochemistry. He discovered the laws of electrolysis, and in his recognition is the eponym of the Faraday constant.
Battery tester. A battery tester is an electronic device intended for testing the state of an electric battery, going from a simple device for testing the charge actually present in the cells and/or its voltage output, to a more comprehensive testing of the battery's condition, namely its capacity for accumulating charge and any possible flaws affecting the battery's performance and security.
A voltameter or coulometer is a scientific instrument used for measuring electric charge (quantity of electricity) through electrolytic action. The SI unit of electric charge is the coulomb. The voltameter should not be confused with a voltmeter, which measures electric potential. The SI unit for electric potential is the volt.
The alternating current signal produced by the flow of this charge is amplified and used as an analogue for the DC voltage applied to the capacitor. The DC input resistance of the electrometer is determined solely by the leakage resistance of the capacitor, and is typically extremely high, (although its AC input impedance is lower).
The inner electrode, which is electrically isolated from the shield, is connected to a meter to measure the charge. [1] In the field of semiconductor design, a coulombmeter consists of a meter used in combination with a metal probe tip to pinpoint locations of excess charge on, for instance a semiconductor device. This application of a ...
The charge control consists of a pressure switch built into the cell, which disconnects the charging current when the internal cell pressure rises above a certain limit; usually 200 pounds per square inch (1.4 MPa) to 300 pounds per square inch (2.1 MPa). This prevents overcharging and damage to the cell.
In practice the conductivity cell is calibrated by using solutions of known specific resistance, ρ*, so the individual quantities l and A need not be known precisely, but only their ratio. [11] If the resistance of the calibration solution is R * , a cell-constant, defined as the ratio of l and A ( C = l ⁄ A ), is derived.