Search results
Results from the WOW.Com Content Network
A linear motor is functionally the same as a rotary electric motor with the rotor and stator circular magnetic field components laid out in a straight line. Where a rotary motor would spin around and re-use the same magnetic pole faces again, the magnetic field structures of a linear motor are physically repeated across the length of the actuator.
Usually utilization category is mentioned in most of the switch gear, with the above contactor stating to be used under AC1 - resistive load & AC3 for motor usage. In electrical engineering utilization categories are defined by IEC standards [1] and indicate the type of electrical load and duty cycle of the loads to ease selection of contactors ...
Truss rods are frequently made out of steel, though graphite and other materials are sometimes used.. The truss rod can be adjusted to compensate for expansion or contraction in the neck wood due to changes in humidity or temperature, or to compensate for changes in the tension of the strings (the thicker the guitar string, the higher its tension when tuned to correct pitch) or using different ...
If two motors with the same and torque work in tandem, with rigidly connected shafts, the of the system is still the same assuming a parallel electrical connection. The K M {\displaystyle K_{\text{M}}} of the combined system increased by 2 {\displaystyle {\sqrt {2}}} , because both the torque and the losses double.
This assumes that the electrical generator converts 90% of the engine's output into electrical energy and the traction motors convert 90% of this electrical energy back into mechanical energy. [citation needed] Calculation: 0.9 × 0.9 = 0.81 Individual traction motor ratings usually range up 1,600 kW (2,100 hp).
In electrical engineering the load factor is defined as the average load divided by the peak load in a specified time period. [1] It is a measure of the utilization rate, or efficiency of electrical energy usage; a high load factor indicates that load is using the electric system more efficiently, whereas consumers or generators that underutilize the electric distribution will have a low load ...
Splined joints, calculation of load capacity – Part 1: general basis: Active: DIN 5473: Logic and set theory; symbols and concepts: Active: DIN 5474: Signs in mathematical logic: Withdrawn: DIN 5473: DIN 5475-1: Complex quantities; nomenclature: Withdrawn: DIN 5483-3: DIN 5480-1: Involute splines based on reference diameters – Part 1 ...
A threaded rod, also known as a stud, is a relatively long rod that is threaded on both ends; the thread may extend along the complete length of the rod. [1] They are designed to be used in tension. [2] Threaded rod in bar stock form is often called all-thread (ATR); other names include fully-threaded rod, redi-rod, continuously-threaded rod ...