Search results
Results from the WOW.Com Content Network
With regard to SPARC, the non-maskable interrupt (NMI), despite having the highest priority among interrupts, can be prevented from occurring through the use of an interrupt mask. [1] An NMI is often used when response time is critical or when an interrupt should never be disabled during normal system operation.
The Interrupt flag (IF) is a flag bit in the CPU's FLAGS register, which determines whether or not the (CPU) will respond immediately to maskable hardware interrupts. [1] If the flag is set to 1 maskable interrupts are enabled. If reset (set to 0) such interrupts will be disabled until
On uni-processor systems, the simplest solution to achieve mutual exclusion is to disable interrupts during a process's critical section. This will prevent any interrupt service routines from running (effectively preventing a process from being preempted). Although this solution is effective, it leads to many problems.
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
If set, enables support for the virtual interrupt flag (VIF) in virtual-8086 mode. 1: PVI: Protected-mode Virtual Interrupts: If set, enables support for the virtual interrupt flag (VIF) in protected mode. 2: TSD: Time Stamp Disable: If set, RDTSC instruction can only be executed when in ring 0, otherwise RDTSC can be used at any privilege ...
The IRR specifies which interrupts are pending acknowledgement, and is typically a symbolic register which can not be directly accessed. The ISR register specifies which interrupts have been acknowledged, but are still waiting for an end of interrupt (EOI). The IMR specifies which interrupts are to be ignored and not acknowledged.
1. Open the Windows Control Panel. 2. Click Programs.. 3. Click DataMask by AOL. 4. Click Change/Remove, Add/Remove, or Uninstall. - If there is no entry in the Add/Remove Programs window for DataMask by AOL, contact our technical support team at datamaskhelp@aol.com.
On the Zilog Z80, executing DI (disable interrupts) followed by HALT (wait for an interrupt) results in the CPU staying frozen indefinitely, waiting for an interrupt that cannot happen. However, the non-maskable interrupt signal can be used to break out of this state, making this pair not a true HCF.