Ad
related to: stone masonry how to install a wall anchors
Search results
Results from the WOW.Com Content Network
An anchor plate, floor plate [1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against lateral bowing. Anchor plates are made of cast iron, sometimes wrought iron or steel, and are often made in a decorative style. [2]
Note that the Wikipedia page on stone arches is about stone-arch bridges exclusively, and the arch page is about all arches, including non-stone. [4] Rubble masonry. Use of rubble in masonry: antonymous to ashlar masonry. Can be infill in an ashlar wall, used in cyclopean concrete, and other contexts. [4] The term is antonymous to "ashlar". Dry ...
Expandable wall anchors with toggle arms. A drywall anchor, also known as a wall anchor, is an insert that, combined with the appropriate screw, can create a strong mount anywhere on a drywall panel or similar hollow wall. [1] A drywall anchor goes between the screw and the drywall, gripping the drywall much more effectively than a screw would. [2]
Most exterior veneer systems hang stone from a support wall by pins and anchors allowing air space between, essentially using stone as a rain screen. Anchorage systems are superior for exterior use because they permit any water that permeates the veneer to escape, while air space allows the materials of the supporting substrate wall to expand ...
Before commercial wall plugs, fixings were made to brick or masonry walls by first chiselling a groove into a soft mortar joint, hammering in a crude wooden plug and then attaching to the wooden plug. This was time consuming and required a large hole, thus more patching of the wall afterwards. It also limited the holes' location to the mortar ...
Molly fastener. A molly or molly bolt (often misspelled moly [1]) is a type of screw fastener that fastens objects to plaster or gypsum board hollow walls by providing an anchor to be lodged inside a hole and expanded once in position.
Typically in the form of a horizontal wire or rod, or a helical anchor, a tieback is commonly used along with other retaining systems (e.g. soldier piles, sheet piles, secant and tangent walls) to provide additional stability to cantilevered retaining walls. [1]
Bonded anchors are also referred as adhesive anchors [9] or chemical anchors. The anchoring material is an adhesive (also called mortar) [3] usually consisting of epoxy, polyester, or vinylester resins. [1] In bonded anchors, the force-transfer mechanism is based on bond stresses provided by binding organic materials.
Ad
related to: stone masonry how to install a wall anchors