Search results
Results from the WOW.Com Content Network
A DOCSIS 3.0 cable modem A cable modem termination system (CMTS) A DOCSIS architecture includes two primary components: a cable modem located at the customer premises, and a cable modem termination system (CMTS) located at the CATV headend. [27] The customer PC and associated peripherals are termed customer-premises equipment (CPE). The CPE are ...
It is used mainly with DOCSIS and DSL carriers, by encapsulating PPP frames in ATM AAL5. Point-to-Point Protocol over Asynchronous Transfer Mode (PPPoA) is specified by The Internet Engineering Task Force (IETF) in RFC 2364. [1] It offers standard PPP features such as authentication, encryption, and compression.
Technical Report 069 (TR-069) is a document by the Broadband Forum that specifies the CPE WAN Management Protocol (CWMP). CWMP is an application layer protocol for remote management and provisioning of customer-premises equipment (CPE) connected to an Internet Protocol (IP) network.
DOCSIS RFI 1.1 [16] later added more robust and standardized QoS mechanisms to DOCSIS. DOCSIS 2.0 added support for S-CDMA PHY, while DOCSIS 3.0 added IPv6 support and channel bonding to allow a single cable modem to use concurrently more than one upstream channel and more than one downstream channel in parallel.
OTG adds a fifth pin to the standard USB connector, called the ID-pin; the micro-A plug has the ID pin grounded, while the ID in the micro-B plug is floating. A device with a micro-A plug inserted becomes an OTG A-device, and a device with a micro-B plug inserted becomes a B-device. The type of plug inserted is detected by the state of the pin ID.
Tulsi Gabbard, Donald Trump’s pick to lead the intelligence community, was briefly placed on a Transportation Security Administration list that prompts additional security screening before ...
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for duplex, bidirectional traffic. They usually use port numbers that match the services of the corresponding TCP or UDP implementation, if they exist.
Holiday party season is in full swing, and we're willing to bet if you clicked on this story, you're looking for festive ways to spice up your Christmas party this year.. Eggnog is a holiday ...