enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Vise - Wikipedia

   en.wikipedia.org/wiki/Vise

   The jaw opening of an engineer's vise generally equals its jaw width, though it may be wider. An engineer's vise is bolted onto the top surface of a workbench, [5] with the face of the fixed jaw just forward of its front edge. The vise may include other features such as a small anvil on the back of its body. Most engineer's vises have a swivel ...

3. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   The R8 system is commonly used with collets ranging in size from 1 ⁄ 8 ″ to 3 ⁄ 4 ″ in diameter or tool holders with the same or slightly larger diameters. The collets or tool holders are placed directly into the spindle and the drawbar is tightened into the top of the collet or tool holder from above the spindle.

4. Automatic tool changer - Wikipedia

   en.wikipedia.org/wiki/Automatic_Tool_Changer

   But if even more tools are required, then an ATC is needed. The tools are stored in a magazine. This allows the machine to work with a large number of tools without operator intervention. The main parts of an automatic tool changer are the base, the gripper arm, the tool holder, the support arm, and the tool magazines. [2]

5. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.

6. Shaper - Wikipedia

   en.wikipedia.org/wiki/Shaper

   A single-point cutting tool is rigidly held in the tool holder, which is mounted on the ram. The work piece is rigidly held in a vise or clamped directly on the table. The table may be supported at the outer end. The ram reciprocates and the cutting tool, held in the tool holder, moves forwards and backwards over the work piece.

7. Fixture (tool) - Wikipedia

   en.wikipedia.org/wiki/Fixture_(tool)

   A common type of fixture, used in materials tensile testing (Grip-Engineering). A fixture is a work-holding or support device used in the manufacturing industry. [1] [2] Fixtures are used to securely locate (position in a specific location or orientation) and support the work, ensuring that all parts produced using the fixture will maintain conformity and interchangeability.