Search results
Results from the WOW.Com Content Network
A cantilever bridge is a bridge built using structures that project horizontally into space, supported on only one end (called cantilevers).For small footbridges, the cantilevers may be simple beams; however, large cantilever bridges designed to handle road or rail traffic use trusses built from structural steel, or box girders built from prestressed concrete.
BS 5400-1:1988 Steel, concrete and composite bridges. General statement. BS 5400-2:2006 Steel, concrete and composite bridges. Specification for loads. BS 5400-3:2000 Steel, concrete and composite bridges. Code of practice for design of steel bridges. (This part of standard is being partially replaced) BS 5400-4:1990 Steel, concrete and ...
A similar bridge on this river was fabricated ashore and pushed across its pylons. Single box girder bridge , flyover above eastern approach of the San Francisco–Oakland Bay Bridge. A box girder bridge, or box section bridge, is a bridge in which the main beams comprise girders in the shape of a hollow box.
Steel column members must be verified as adequate to prevent buckling after axial and moment requirements are met. There are currently two common methods of steel design: The first method is the Allowable Strength Design (ASD) method. The second is the Load and Resistance Factor Design (LRFD) method. Both use a strength, or ultimate level ...
A girder bridge is a bridge that uses girders as the means of supporting its deck. [1] The two most common types of modern steel girder bridges are plate and box. [citation needed] The term "girder" is often used interchangeably with "beam" in reference to bridge design.
The narrow section at mid-span gives the bridge profile a slight arch shape making this design particularly useful when large headroom is required. The profile also makes the bridge more architecturally pleasing than a beam bridge. Rigid-frame design may be the most efficient bridge type for spans between 35 and 80 feet (11 and 24 m). [5]
A simple lattice truss will transform the applied loads into a thrust, as the bridge will tend to change length under load. This is resisted by pinning the lattice members to the top and bottom chords, which are more substantial than the lattice members, but which may also be fabricated from relatively small elements rather than large beams.
In a plate girder bridge, the plate girders are typically I-beams made up from separate structural steel plates (rather than rolled as a single cross-section), which are welded or, in older bridges, bolted or riveted together to form the vertical web and horizontal flanges of the beam. In some cases, the plate girders may be formed in a Z-shape ...