Ads
related to: isolation transformer ratio chart- Medium Voltage Dry-Type
Request a quote for a mv dry-type
In stock mv dry-type transformers
- Transformer Repair
Request a transformer repair quote
Transformer inspection and repairs
- About Us
Focused On The Transformer Needs Of
Industrial & Commercial Clients.
- Sell Surplus
We Purchase New & Used Transformers
Anywhere In North America.
- Medium Voltage Dry-Type
Search results
Results from the WOW.Com Content Network
An isolation transformer is a transformer used to transfer electrical power from a source of alternating current (AC) power to some equipment or device while isolating the powered device from the power source, usually for safety reasons or to reduce transients and harmonics. [1]
While transformers are usually used to step up or step down the voltages, isolation transformers with a 1:1 ratio are used mostly in safety applications while keeping the voltage the same. If two electronic systems have a common ground, they are not galvanically isolated. The common ground might not normally and intentionally have connection to ...
MIL-STD-1553B specifies the transformer characteristics and turns ratio of 1.4:1 with the higher turns on the isolation resistor side of the stub. The MIL-STD-1553B also specifies the isolation resistors that are placed in series with each connection to the bus.
An isolation transformer links two circuits magnetically, but provides no metallic conductive path between the circuits. An example application would be in the power supply for medical equipment, when it is necessary to prevent any leakage from the AC power system into devices connected to a patient.
The forward converter is a DC/DC converter that uses a transformer to increase or decrease the output voltage (depending on the transformer ratio) and provide galvanic isolation for the load. With multiple output windings, it is possible to provide both higher and lower voltage outputs simultaneously.
To match the impedances, both cables must be connected to a matching transformer with a turns ratio of 2:1. In this example, the 300-ohm line is connected to the transformer side with more turns; the 75-ohm cable is connected to the transformer side with fewer turns. The formula for calculating the transformer turns ratio for this example is:
Assuming the desired voltage is the same on the two and three phase sides, the Scott-T transformer connection (shown right) consists of a centre-tapped 1:1 ratio main transformer, T1, and a √ 3 /2(≈86.6%) ratio teaser transformer, T2. The centre-tapped side of T1 is connected between two of the phases on the three-phase side.
The quarter wave transformer is an alternative to a stub; but, whereas a stub is terminated in a short (or open) circuit and the length is chosen so as to produce the required impedance transformation, the λ/4 transformer is in series with the load and its length and characteristic impedance are designed to produce the required impedance ...
Ads
related to: isolation transformer ratio chart