enow.com Web Search

  1. Ads

    related to: chevy drive shafts for sale

Search results

  1. Results from the WOW.Com Content Network
  2. Muncie SM465 transmission - Wikipedia

    en.wikipedia.org/wiki/Muncie_SM465_transmission

    There have been three different output shafts for pickup trucks. Early four-wheel drive was a short 10 spline. Later, a 35-spline version was for 2 wheel drive, whereas 4WD units had a 32-spline output shaft. [1] The SM465 was the only manual transmission available for 1988-1991 R/V-series trucks and SUVs. [citation needed]

  3. GM 10.5-inch 14-bolt differential - Wikipedia

    en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

    The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles. Additionally, GM incorporates a vibration damper on the yoke, while Dodge positions it on the drive shaft.

  4. New Venture Gear 3500 transmission - Wikipedia

    en.wikipedia.org/wiki/New_Venture_Gear_3500...

    The updated input shaft and bearings carried through to the NV3500. All 5 of these transmissions can be interchanged as a complete unit with the following caveats. "Drop-in" interchanges between GM S (S10 etc.) and C/K trucks will require modification of driveshaft length and crossmember placement. GM S models have a longer tail-shaft than C/K ...

  5. GM 4L60-E transmission - Wikipedia

    en.wikipedia.org/wiki/GM_4L60-E_transmission

    This happened in 1993 for trucks, vans, and SUVs, and 1994 for rear wheel drive passenger cars. In 1996, a bolt-on bell housing was phased in (along with a six-bolt tailhousing) for S-10 Trucks and S-10 Blazers and beginning in 1998 for all other applications.

  6. GM 6L transmission - Wikipedia

    en.wikipedia.org/wiki/GM_6L_transmission

    The 6L 50 (and similar 6L 45) is a 6-speed longitudinally-mounted automatic transmission produced by General Motors.It is very similar in design to the larger GM 6L 80 and 6L 90, and is produced at GM Powertrain plants in Toledo, Ohio; Silao, Guanajuato, Mexico; and by the independent Punch Powerglide company in Strasbourg, France.

  7. Dana 70 - Wikipedia

    en.wikipedia.org/wiki/Dana_70

    The axle tubes were increased to 4 inches (100 mm) diameter and carrier bearings were larger and thicker, the axle shafts were 35 spline only. These upgrades gave the Dana 70HD a gross axle rating of 10,000 lb (4,500 kg). The Dana 70 front drive axles used in the Chevrolet Kodiaks and GMC Topkicks also had these features.

  1. Ads

    related to: chevy drive shafts for sale