Search results
Results from the WOW.Com Content Network
Placing the oil pump low-down uses a near-vertical drive shaft, driven by helical skew gears from the camshaft. Some engines, such as the Fiat Twin Cam engine of 1964, began as OHV engines with an oil pump driven from a conventional camshaft in the cylinder block. When the twin overhead cam engine was developed, the previous oil pump ...
Philips Norelco is the American brand name for electric shavers and other personal care products made by the Consumer Lifestyle division of Philips. [ 1 ] [ 2 ] For personal care products marketed outside the United States, Palau, Micronesia, and the Marshall Islands, Philips used the Philishave trademark until 2006.
Injection pump for a 12-cylinder diesel engine. An injection pump is the device that pumps fuel into the cylinders of a diesel engine. Traditionally, the injection pump was driven indirectly from the crankshaft by gears, chains or a toothed belt (often the timing belt) that also drives the camshaft.
Direct injection means that the fuel is injected into the main combustion chamber of each cylinder. [3] The air and fuel are mixed only inside the combustion chamber. Therefore, only air is sucked into the engine during the intake stroke. The injection scheme is always intermittent (either sequential or cylinder-individual).
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The kilopound per square inch (ksi) is a scaled unit derived from psi, equivalent to a thousand psi (1000 lbf/in 2). ksi are not widely used for gas pressures. They are mostly used in materials science, where the tensile strength of a material is measured as a large number of psi. [4] The conversion in SI units is 1 ksi = 6.895 MPa, or 1 MPa ...
(Reuters) - U.S. President-elect Donald Trump in an interview published on Thursday said he will be talking to Robert F. Kennedy Jr., his nominee to run the Department of Health and Human Services ...
It is similar to that of a piston pump, but the high-pressure seal is stationary while the smooth cylindrical plunger slides through the seal. Plunger-type pumps are often mounted on the side of the injection pump and driven by the camshaft. [4] These pumps usually run at a fuel pressure of 3,600–26,100 psi (250–1,800 bar). [3]