Search results
Results from the WOW.Com Content Network
Fault detection, isolation, and recovery (FDIR) is a subfield of control engineering which concerns itself with monitoring a system, identifying when a fault has occurred, and pinpointing the type of fault and its location. Two approaches can be distinguished: A direct pattern recognition of sensor readings that indicate a fault and an analysis ...
Time-domain reflectometer for cable fault detection A time-domain reflectometer ( TDR ) is an electronic instrument used to determine the characteristics of electrical lines by observing reflected pulses .
This is usually handled with a separate "automated fault-detection system". In the case of the tire, an air pressure monitor detects the loss of pressure and notifies the driver. The alternative is a "manual fault-detection system", such as manually inspecting all tires at each stop. Interference with fault detection in another component.
ATPG (acronym for both automatic test pattern generation and automatic test pattern generator) is an electronic design automation method or technology used to find an input (or test) sequence that, when applied to a digital circuit, enables automatic test equipment to distinguish between the correct circuit behavior and the faulty circuit behavior caused by defects.
Watchdog timers are sometimes used to trigger the recording of system state information—which may be useful during fault recovery [4] —or debug information (which may be useful for determining the cause of the fault) onto a persistent medium. In such cases, a second timer—which is started when the first timer elapses—is typically used ...
The construction of a failure detector is an essential, but a very difficult problem that occurred in the development of the fault-tolerant component in a distributed computer system. As a result, the failure detector was invented because of the need for detecting errors in the massive information transaction in distributed computing systems.
Bidirectional Forwarding Detection (BFD) is a network protocol that is used to detect faults between two routers or switches connected by a link. It provides low-overhead detection of faults even on physical media that doesn't support failure detection of any kind, such as Ethernet , virtual circuits , tunnels and MPLS label-switched paths .
Fault detection coverage that system built-in test will realize; Whether the analysis will be functional or piece-part; Criteria to be considered (mission abort, safety, maintenance, etc.) System for uniquely identifying parts or functions; Severity category definitions