Search results
Results from the WOW.Com Content Network
Lifting line theory supposes wings that are long and thin with negligible fuselage, akin to a thin bar (the eponymous "lifting line") of span 2s driven through the fluid. . From the Kutta–Joukowski theorem, the lift L(y) on a 2-dimensional segment of the wing at distance y from the fuselage is proportional to the circulation Γ(y) about the bar a
In February 1976, work commenced to automate the methods contained in the USAF Stability and Control DATCOM, specifically those contained in sections 4, 5, 6 and 7.The work was performed by the McDonnell Douglas Corporation under contract with the United States Air Force in conjunction with engineers at the Air Force Flight Dynamics Laboratory in Wright-Patterson Air Force Base.
Equations for divergence of a simple beam Divergence can be understood as a simple property of the differential equation(s) governing the wing deflection. For example, modelling the airplane wing as an isotropic Euler–Bernoulli beam, the uncoupled torsional equation of motion is = ′,
A control system includes control surfaces which, when deflected, generate a moment (or couple from ailerons) about the cg which rotates the aircraft in pitch, roll, and yaw. For example, a pitching moment comes from a force applied at a distance forward or aft of the cg, causing the aircraft to pitch up or down.
Deflection of control surfaces modifies the pressure distribution over the vehicle, and these are dealt with by including perturbations in forces and moments due to control deflection. The fin deflection is normally denoted (zeta). Including these terms, the equations of motion become:
In two-dimensional flow around a uniform wing of infinite span, the slope of the lift curve is determined primarily by the trailing edge angle. The slope is greatest if the angle is zero; and decreases as the angle increases. [6] [7] For a wing of finite span, the aspect ratio of the wing also significantly influences the slope of the curve. As ...
A wing of infinite span and uniform airfoil segment (or a 2D wing) would experience no induced drag. [11] The drag characteristics of a wing with infinite span can be simulated using an airfoil segment the width of a wind tunnel. [12] An increase in wingspan or a solution with a similar effect is one way to reduce induced drag.
A raised aileron reduces lift on that wing and a lowered one increases lift, so moving the aileron control in this way causes the left wing to drop and the right wing to rise. This causes the aircraft to roll to the left and begin to turn to the left. Centering the control returns the ailerons to the neutral position, maintaining the bank angle ...