enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Oxy-fuel welding and cutting - Wikipedia

   en.wikipedia.org/wiki/Oxy-fuel_welding_and_cutting

   An oxygen tank is especially dangerous because the gas is stored at a pressure of 21 MPa (3,000 psi; 210 atm)) when full. If the tank falls over and damages the valve, the tank can be jettisoned by the compressed oxygen escaping the cylinder at high speed. Tanks in this state are capable of breaking through a brick wall. [19]

3. MAPP gas - Wikipedia

   en.wikipedia.org/wiki/MAPP_gas

   A set of MAPP and oxygen cylinders is used for oxy-fuel welding and cutting.. MAPP gas was a trademarked name, belonging to The Linde Group, a division of the former global chemical giant Union Carbide, for a fuel gas based on a stabilized mixture of methylacetylene (propyne), propadiene and propane.

4. Oxygen tank - Wikipedia

   en.wikipedia.org/wiki/Oxygen_tank

   Medical use liquid oxygen airgas tanks are typically 2.4 MPa (350 psi). [citation needed] All equipment coming into contact with high pressure oxygen must be "oxygen clean" and "oxygen compatible", to reduce the risk of fire. [3] [4] "Oxygen clean" means the removal of any substance that could act as a source of ignition. "Oxygen compatible ...

5. Flashback arrestor - Wikipedia

   en.wikipedia.org/wiki/Flashback_arrestor

   Flashback arrestors with different size and flow rate, and different connections. A flashback arrestor or flash arrestor is a gas safety device most commonly used in oxy-fuel welding and cutting to stop the flame or reverse flow of gas back up into the equipment or supply line. It protects the user and equipment from damage or explosions.

6. Thermal lance - Wikipedia

   en.wikipedia.org/wiki/Thermal_lance

   A thermal lance, thermic lance, oxygen lance, or burning bar is a tool that heats and melts steel in the presence of pressurized oxygen to create very high temperatures for cutting. It consists of a long steel tube packed with alloy steel rods, which serve as fuel; these are sometimes mixed with aluminum rods to increase the heat output.

7. Oxyhydrogen - Wikipedia

   en.wikipedia.org/wiki/Oxyhydrogen

   Oxyhydrogen is a mixture of hydrogen (H 2) and oxygen (O 2) gases. This gaseous mixture is used for torches to process refractory materials and was the first [1] gaseous mixture used for welding. Theoretically, a ratio of 2:1 hydrogen:oxygen is enough to achieve maximum efficiency; in practice a ratio 4:1 or 5:1 is needed to avoid an oxidizing ...