Search results
Results from the WOW.Com Content Network
This is a list of some binary codes that are (or have been) used to represent text as a sequence of binary digits "0" and "1". Fixed-width binary codes use a set number of bits to represent each character in the text, while in variable-width binary codes, the number of bits may vary from character to character.
The word 'Wikipedia' represented in ASCII binary code, made up of 9 bytes (72 bits). A binary code represents text, computer processor instructions, or any other data using a two-symbol system. The two-symbol system used is often "0" and "1" from the binary number system. The binary code assigns a pattern of binary digits, also known as bits ...
In the table below, the column "ISO 8859-1" shows how the file signature appears when interpreted as text in the common ISO 8859-1 encoding, with unprintable characters represented as the control code abbreviation or symbol, or codepage 1252 character where available, or a box otherwise. In some cases the space character is shown as ␠.
BCD (binary-coded decimal), also called alphanumeric BCD, alphameric BCD, BCD Interchange Code, [1] or BCDIC, [1] is a family of representations of numerals, uppercase Latin letters, and some special and control characters as six-bit character codes. Unlike later encodings such as ASCII, BCD codes were not standardized. Different computer ...
A code point is a value or position of a character in a coded character set. [9] A code space is the range of numerical values spanned by a coded character set. [9] [11] A code unit is the minimum bit combination that can represent a character in a character encoding (in computer science terms, it is the word size of the character encoding).
Binary counting follows the exact same procedure, and again the incremental substitution begins with the least significant binary digit, or bit (the rightmost one, also called the first bit), except that only the two symbols 0 and 1 are available. Thus, after a bit reaches 1 in binary, an increment resets it to 0 but also causes an increment of ...
A binary-to-text encoding is encoding of data in plain text. More precisely, it is an encoding of binary data in a sequence of printable characters . These encodings are necessary for transmission of data when the communication channel does not allow binary data (such as email or NNTP ) or is not 8-bit clean .
IEC 60027-2 Amendment 2, as published in January 1999, was the first international standard defining the binary prefixes, as proposed by International Electrotechnical Commission (IEC) since 1996 (kibi-(Ki), mebi-(Mi), gibi-(Gi) and tebi-(Ti)) [1] but extended them up to pebi (Pi) and exbi-(Ei).