enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.

3. Types of press tools - Wikipedia

   en.wikipedia.org/wiki/Types_of_press_tools

   Punch Holder: This plate is used to accommodate the punches of press tool. Punches : To perform cutting and non cutting operations either plain or profiled punches are used. Die Plate: Die plate will have similar profile of the component where cutting dies usually have holes with land and angular clearance and non cutting dies will have profiles.

4. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves). A hole punch can also refer to similar tools for other materials, such as leather, cloth, or sheets ...

5. Punch press - Wikipedia

   en.wikipedia.org/wiki/Punch_press

   A die set consists of a set of punches and dies which, when pressed together, form a hole in a workpiece (and may also deform the workpiece in some desired manner). The punches and dies are removable, with the punch being attached to the ram during the punching process. The ram moves up and down in a vertically linear motion, forcing the punch ...

6. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   A die is located on the opposite side of the workpiece and supports the material around the perimeter of the hole and helps to localize the shearing forces for a cleaner edge. There is a small amount of clearance between the punch and the die to prevent the punch from sticking in the die and so less force is needed to make the hole.

7. Press brake - Wikipedia

   en.wikipedia.org/wiki/Press_brake

   Offset dies—a combination punch and die set that bends two angles in one stroke to produce a Z shape. Hemming dies—two-stage dies combining an acute angle die with a flattening tool. Seaming dies—There are a number of ways to build dies to produce seams in sheets and tubes. Radius dies—A radiussed bend can be produced by a rounded punch.