enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ring binder - Wikipedia

   en.wikipedia.org/wiki/Ring_binder

   A standard 8 + 1 ⁄ 2 by 11 inches (220 mm × 280 mm) sheet of paper has three holes with spacing of 4 + 1 ⁄ 4 inches (110 mm). There is a variant for half-letter size pages (8 + 1 ⁄ 2 by 5 + 1 ⁄ 2 inches or 220 mm × 140 mm), whose three rings are 2 + 3 ⁄ 4 inches (70 mm) apart. "Ledger" size binders hold 11-by-17-inch (28 by 43 cm ...

3. Comb binding - Wikipedia

   en.wikipedia.org/wiki/Comb_binding

   Standard sizes are 4.8 mm (3 ⁄ 16 in) (for 16 sheets of 20# paper) up to 51 mm (2 in) (for 425 sheets). Spine lengths are generally 280 mm (11 in) to match the length of letter-size paper. Spine lengths are generally 280 mm (11 in) to match the length of letter-size paper.

4. Wire binding - Wikipedia

   en.wikipedia.org/wiki/Wire_binding

   Wire binding is a popular commercial book binding method, and is known by various names, including double loop wire, double-o, ring wire, twin loop wire, wire comb, wire-o, wirebind and wiro. With this binding method, users insert their punched pages onto a C-shaped spine , and then use a wire closer to squeeze the spine until it is round. [ 1 ]

5. Loose leaf - Wikipedia

   en.wikipedia.org/wiki/Loose_leaf

   In North America, 3-hole binders for letter-size papers typically have a width of 1/2 inch, 1 inch, 1.5 inches, 2 inches, 3 inches or 4 inches; in ISO system, binders typically have a width of less than 3 cm. “Discbound” loose leaf systems, which uses separate “discs” to hold covers and pages. Staples and Office Depot sell discbound ...

6. Foolscap folio - Wikipedia

   en.wikipedia.org/wiki/Foolscap_folio

   Ring binders or lever arch files designed to hold foolscap folios are often used to hold A4 paper (210 × 297 mm, 8 + 1 ⁄ 4 × 11 + 3 ⁄ 4 in). The slightly larger size of such a binder offers greater protection to the edges of the pages it contains.

7. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   The diameter of the holes varies between manufacturers, with typical values being 1 ⁄ 4 to 5 ⁄ 16 inch (6 to 8 mm). The 5 ⁄ 16 value is most commonly used, as it allows for looser tolerances in both ring binder and paper punching. The distance to the paper edge also varies, with 1 ⁄ 2 inch (13 mm) hole